need help with conector
#1
Member
Thread Starter
Join Date: Dec 2007
Location: mattoon illinois
Posts: 199
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92camaro,86 camaro
Engine: 355
Transmission: 700r4
#2
Senior Member
iTrader: (2)
Re: need help with conector
Black wire with white stripe is a ground, grey wire with black stripe is 4x4LOW engage signal to PCM, I forget what brown is for right off hand.
This connector can be removed and discarded fr the harness, it's nothing pertinent or useful to a thirdgen swap.
This connector can be removed and discarded fr the harness, it's nothing pertinent or useful to a thirdgen swap.
#3
Member
Thread Starter
Join Date: Dec 2007
Location: mattoon illinois
Posts: 199
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92camaro,86 camaro
Engine: 355
Transmission: 700r4
Thank you for response my project was stopped because I couldn't figure this out now I can get back to it
#5
Senior Member
iTrader: (2)
Re: need help with conector
Are you trying to use the truck fuse block as well?
I looked a a few harnesses I have here, and didn't see that connector anywhere in a engine harness, but I did find that connector in a partial body harness from a 04 I have. Sorry I can't help you with that one, I'm not sure what it is.
I looked a a few harnesses I have here, and didn't see that connector anywhere in a engine harness, but I did find that connector in a partial body harness from a 04 I have. Sorry I can't help you with that one, I'm not sure what it is.
#7
Moderator
iTrader: (14)
Join Date: Mar 2000
Location: Littleton, CO USA
Posts: 43,169
Likes: 0
Received 35 Likes
on
34 Posts
Car: 82 Berlinetta/57 Bel Air
Engine: LS1/LQ4
Transmission: 4L60E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Trace the wires back to the PCM connector and get the pin location.
If they don't go back to the PCM, you don't need them.
If they don't go back to the PCM, you don't need them.
Thread
Thread Starter
Forum
Replies
Last Post