wolfe craft anti roll bar setting?
#1
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Apr 2002
Location: Waterloo, Iowa
Posts: 4,671
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 firebird with 98 firebird interi
Engine: pump gas 427sbc Dart Lil M 13.5:1
Transmission: Oldani TH400 w/ BTE 9" convertor
Axle/Gears: 31 spline Moser/full spool/4.11Rich
wolfe craft anti roll bar setting?
I had to cut mine out to remove center section for gear swap, i wrote about it in other posts long ago, but now i have it tack welded into place and will finish it tomorrow, but i cant for the life of me remember how they said to set it. so if any of you recall what the destructions say lemme know.
I know the front end has to be jacked off the ground, meaure the rockers on driver and pass. side, but i cant remember if the measurements are to be even, or if preloading one side or the other is needed...makes me mad i'm having a brain fart, but i would think it'd be even measurements with front end up and drivers weight in the front seat.
lemme know
thanks
josh
I know the front end has to be jacked off the ground, meaure the rockers on driver and pass. side, but i cant remember if the measurements are to be even, or if preloading one side or the other is needed...makes me mad i'm having a brain fart, but i would think it'd be even measurements with front end up and drivers weight in the front seat.
lemme know
thanks
josh
#2
Member
Join Date: May 2002
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 Formula
Engine: 355
Transmission: TH400
Axle/Gears: 5.00
Re: wolfe craft anti roll bar setting?
Jack the front of your vehicle up until the front wheels just start to come off the ground. Ensure that the jack is dead center on the front cross member. Measure the lower corner of both the Driver and Pasenger door jam or the top of the wheel well opening (centered on the wheel). You will be looking for the Passenger side to be about 1/16" - 1/8" lower than the drivers side. Adjust the passenger side sway bar link to accomplish this. tighten the jam nuts and recheck.
Straight from the instruction sheet.
I just installed one 3 weeks ago......
----------
Also done with no driver in the vehicle.....When you make your adjusments.
Straight from the instruction sheet.
I just installed one 3 weeks ago......
----------
Also done with no driver in the vehicle.....When you make your adjusments.
Last edited by tommyboy; 04-06-2008 at 05:15 PM. Reason: Automerged Doublepost
#3
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Apr 2002
Location: Waterloo, Iowa
Posts: 4,671
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 firebird with 98 firebird interi
Engine: pump gas 427sbc Dart Lil M 13.5:1
Transmission: Oldani TH400 w/ BTE 9" convertor
Axle/Gears: 31 spline Moser/full spool/4.11Rich
Re: wolfe craft anti roll bar setting?
Thank you much...exactly what i needed to know.
Thread
Thread Starter
Forum
Replies
Last Post
ProtoMaster22
Engine/Drivetrain/Suspension Parts for Sale
1
08-26-2015 07:50 AM