first pass on new motor
#1
first pass on new motor
made it to the track last night made first pass on new set up went 11.92 @ 112 with a 1.93 60ft with no tunning at all then i had really bad oil pressure issue oil pressure went from 60 psi to zero back up yhen back down no noises or anything tried 2 different gauges same problem i dont think i hurt anything but i am going to pull motor and check just to be sure motor builder said he would warrenty any problems better safe than sorry i guess
#2
Supreme Member
iTrader: (3)
Re: first pass on new motor
How much & what visc oil? What type pressure gauge?
I've heard that mech gauges with a big enough line will show every fluctuation.
Are you running just enough oil to get thru the traps, or a thin visc like straight 20 wt?
Agreed, better safe than sorry.
Good luck
I've heard that mech gauges with a big enough line will show every fluctuation.
Are you running just enough oil to get thru the traps, or a thin visc like straight 20 wt?
Agreed, better safe than sorry.
Good luck
#3
Re: first pass on new motor
i actually have hooked 2 different gauges up 1 electric and 1 mech oil i am running is royal purple 10w30 6 1/2 quarts i would think that if it were a bad pump it would have little to no pressure all the time
#5
Senior Member
Join Date: May 2001
Location: springfield,IL
Posts: 745
Likes: 0
Received 0 Likes
on
0 Posts
Car: T/A / Grand Am
Engine: 383 SBC
Transmission: glide
Axle/Gears: 9" ford 5.67
Re: first pass on new motor
The pump may have come loose. Internal oil leak. Seen it before.
#6
Senior Member
iTrader: (8)
Join Date: Aug 2007
Location: Southern Wisconsin
Posts: 1,341
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 Camaro
Engine: 383 Stroker
Transmission: Probuilt 700 R4
Axle/Gears: 3.73
Re: first pass on new motor
what are the specs on the motor. Thats seems pretty stout for a bad 60 ft time
Thread
Thread Starter
Forum
Replies
Last Post