WTB: Rear metal brake line mc to rear end
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Oct 1999
Location: Carrollton, TX, USA
Posts: 779
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Chevy Camaro RS
Engine: 305 TBI
Transmission: T-56
WTB: Rear metal brake line mc to rear end
I need the metal brake line that goes from the master cylinder to the rear of the car (around the fuel filter). I actually only need about the last 2 feet or so.
And actually if I can get 2 people that have this available.....I will buy both.
And actually if I can get 2 people that have this available.....I will buy both.
#2
Member
iTrader: (1)
Join Date: Mar 2004
Location: conway new hampshire
Posts: 158
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 z28
Engine: 355 TPI W/305 HEADS
Transmission: 700r4
Axle/Gears: 3/73's
your most likely have to make one from scratch, thats what i had to do.. use your old fittings and by bulk line from gm and get your hands on an iso flaring kit..its not that hard to do...good luck..
#3
Junior Member
Join Date: Jun 2005
Location: Tallahassee, FL
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
Car: a four letter word that I can't say in GM world
Engine: V6's
Transmission: T5's
have from '91 RS
Line from MC to back, not sure on shipping cost, $10.00 + shipping!
Last edited by roywilson1967; 06-22-2005 at 11:53 PM.
#5
Junior Member
Join Date: Jun 2005
Location: Tallahassee, FL
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
Car: a four letter word that I can't say in GM world
Engine: V6's
Transmission: T5's
sent you an email to your yahoo account regarding shipping, depending on cost for whole line or snip the end... yes, paypal will work!
Thread
Thread Starter
Forum
Replies
Last Post
TA8487
Engine/Drivetrain/Suspension Wanted
1
08-16-2015 12:21 PM