Third Generation F-Body Message Boards

Search: Posts Made By: Rallysport91
Showing results 1 to 13 of 13
Search took 0.12 seconds.
Forum: Electronics
05-07-2007, 01:48 PM
Replies: 5
Views: 850
Posted By Rallysport91

Re: cluster panel bulb replacement

Go to www.superbrightleds.com, they have a lot of direct replacment leds for out dashes and other vehicles. The also have serveral different colors to choose from.
Forum: Tech / General Engine
07-06-2006, 01:57 PM
Replies: 2
Views: 409
Posted By Rallysport91

ECM VSS Question

I have done the tpi swap in my 91' and it orginally had 2.73 gears and I installed a set of 3.42's. I have not changed my drive and driven gears yet, but am still driving the car. Will this...
Forum: Tech / General Engine
07-05-2006, 05:03 PM
Replies: 8
Views: 456
Posted By Rallysport91

nothing as of yet..it was a foreshadowing...

nothing as of yet..it was a foreshadowing thought. I am planning on better heads and a bigger cam and I needed new injectors so i planned ahead. I have never had a problem with them as far as...
Forum: Tech / General Engine
07-05-2006, 04:36 PM
Replies: 8
Views: 456
Posted By Rallysport91

I have 23# accel injectors and I use an...

I have 23# accel injectors and I use an adjustable fuel pressure regulator. I haven't really had any issues with the milage till recently..Is it ok to back off the pressure very much with bigger...
Forum: Tech / General Engine
07-05-2006, 04:23 PM
Replies: 8
Views: 456
Posted By Rallysport91

I usually foul out plugs with a year or maybe a...

I usually foul out plugs with a year or maybe a little more and it always smells rich..especially at start up. When I did the tpi and engine swap I don't believe I replaced the oxygen sensors and...
Forum: Tech / General Engine
07-05-2006, 04:05 PM
Replies: 8
Views: 456
Posted By Rallysport91

Bad Gas Milage

Just looking for opionons from you guys. I have a 350 crate engine with a TPI with 3.42 gears. I noticed latey that my fuel economy has dropped off quite a bit. I haven't made any changes lately...
Forum: Body
06-20-2006, 07:57 AM
Replies: 5
Views: 520
Posted By Rallysport91

If I went with 4th gen seats what color would...

If I went with 4th gen seats what color would look good with my all red interior? I have never seen any red 4th gen leather seats.
Forum: Body
06-19-2006, 04:46 PM
Replies: 5
Views: 520
Posted By Rallysport91

Is ther any leather out there?

I have a 91' RS that came stock with red leather seats. I have since managed to let my t-tops leak on the drivers seat and it has become cracked and brittle. Do you guys know of anywhere to find...
Forum: Auto Detailing and Appearance
07-28-2005, 04:48 PM
Replies: 5
Views: 596
Posted By Rallysport91

C5 Wheels on a '91

Do guys know if it is possible to put C5 wheels on a thirdgen with drum brakes in the back. If so what needs to be done: spacers?
Forum: DFI and ECM
03-07-2003, 11:40 AM
Replies: 0
Views: 376
Posted By Rallysport91

Motor feels like it's dying off..due to prom?

I did a 305 to 350 engine swap and i put in a crate motor that has about 50 more horsepower than the stock z28's for a 91'. I bought a prom for a stock motor and i need to know what the rev limiter...
Forum: Electronics
12-03-2001, 03:05 PM
Replies: 4
Views: 1,128
Posted By Rallysport91

so basically I will need to find out which color...

so basically I will need to find out which color wire for the speedo is coming out of the ecm and connect it to the speedo wire from the dash harness to the actuall speedo, right?
Forum: Electronics
12-02-2001, 11:58 PM
Replies: 1
Views: 532
Posted By Rallysport91

I have a Clifford AvantGaurd III and it has dual...

I have a Clifford AvantGaurd III and it has dual motion sensors. One for the outside for anyone lurking to close to long and one for the inside that they will mount in your console. On most alarms...
Forum: Electronics
12-02-2001, 11:26 PM
Replies: 4
Views: 1,128
Posted By Rallysport91

305 tbi to 350 tpi swap, speedo question

Ok, I have a 91rs that had a 305 tbi that now has a 350 tpi. This is the delema. On the 305 engine wire harness it had a speed buffer that was wired in right by the junction block on the fire wall....
Showing results 1 to 13 of 13


 
Forum Jump


All times are GMT -5. The time now is 04:18 AM.