Search: Posts Made By: mojo_jojoe4
Showing results 1 to 31 of 31
Search took 0.13 seconds.
Forum: LTX and LSX
09-06-2013, 02:12 PM
Replies: 2
Views: 518
Posted By mojo_jojoe4

Re: Converted TPI/LT1 problems

The fuel pump I replaced was the Granetelli 255LPH from Jegs, and the FPR was one they found that had the bracket on the correct side for my mounting purposes was for a Buick Rendevous.
Forum: LTX and LSX
09-06-2013, 02:03 PM
Replies: 2
Views: 518
Posted By mojo_jojoe4

Converted TPI/LT1 problems

First off, my timing is way too high, it's jumping off the marks, and I try to turn the distributor, but I can only turn it so much and it hits the back of the intake where the bolt is on the...
Forum: LTX and LSX
08-12-2013, 06:13 AM
Replies: 10
Views: 5,983
Posted By mojo_jojoe4

Re: 100 PSI Fuel Pressure LT1

Ok, will the pressure read high if I'm checking it with the vacuum line still connected?
Forum: LTX and LSX
08-10-2013, 06:28 PM
Replies: 10
Views: 5,983
Posted By mojo_jojoe4

Re: 100 PSI Fuel Pressure LT1

I'm using NGK TR55 plugs.
Forum: LTX and LSX
08-10-2013, 06:27 PM
Replies: 10
Views: 5,983
Posted By mojo_jojoe4

Re: 100 PSI Fuel Pressure LT1

OK, so I ran it for a little bit, then pulled #3 plug. It wasn't soaked in gas, but it was very black and it did smell like gas. I just changed the plugs a couple of months ago and I bet I've only...
Forum: LTX and LSX
08-08-2013, 09:34 PM
Replies: 10
Views: 5,983
Posted By mojo_jojoe4

Re: 100 PSI Fuel Pressure LT1

What's the easiest way to check to see if either of those are clogged?

I'll check the plugs tomorrow. Can I check them without it running for a while, or should I check them after I have had the...
Forum: LTX and LSX
08-08-2013, 08:01 PM
Replies: 10
Views: 5,983
Posted By mojo_jojoe4

Re: 100 PSI Fuel Pressure LT1

OK, so I just replaced the fuel pressure regulator, had to take it in b/c the regulators had the mount on the opposite side, so they found one that had it on the side I need, hooked it up, still...
Forum: LTX and LSX
08-06-2013, 11:15 AM
Replies: 10
Views: 5,983
Posted By mojo_jojoe4

Re: 100 PSI Fuel Pressure LT1

I just bought the gauge at the auto store.

Granatelli 255LPH I just bought from Jegs
Forum: LTX and LSX
08-05-2013, 02:12 PM
Replies: 10
Views: 5,983
Posted By mojo_jojoe4

100 PSI Fuel Pressure LT1

So I bought a fuel pressure gauge before I replaced the fuel pump to decide what was wrong. I replaced the pump and now my pressure is 100 PSI at idle. Turn the key it's goes up to 80, then 100...
07-31-2013, 08:04 AM
Replies: 8
Views: 784
Posted By mojo_jojoe4

Re: Walbro Fuel Pump Question

OK, so I replaced the fuel pump and put gas in the tank and it starts up like a dream. I hooked up a FP gauge and when the key is turned, the pressure shoots up to like 80PSI then when started, it...
07-10-2013, 11:00 AM
Replies: 2
Views: 760
Posted By mojo_jojoe4

Re: Wanted 1989 Firebird Formula 350

How much are you looking to get for your 89?
06-20-2013, 07:32 AM
Replies: 2
Views: 682
Posted By mojo_jojoe4

Re: 19" wheels. Black with chrome lip

Can you send me pics of all 4 wheels? Can you include the tire sizes and brand also? I'm very interested and would be a nice weekend getaway for me.
06-19-2013, 03:28 PM
Replies: 8
Views: 784
Posted By mojo_jojoe4

Re: Walbro Fuel Pump Question

OK, I'm stupid, how do you do that?
06-18-2013, 08:36 PM
Replies: 8
Views: 784
Posted By mojo_jojoe4

Re: Walbro Fuel Pump Question

How do you do that?
06-18-2013, 02:33 PM
Replies: 8
Views: 784
Posted By mojo_jojoe4

Re: Walbro Fuel Pump Question

Yes, the pump will kick on, and there is fuel up at the shrader valve when I press the nipple.
06-18-2013, 02:22 PM
Replies: 8
Views: 784
Posted By mojo_jojoe4

Walbro Fuel Pump Question

I have a 91 Firebird, but the motor in it isn't the stock one and I have no idea what year, plus I had a converted LT1 intake put on. I know it was a 255 Walbro. A couple weekends ago it wouldn't...
05-13-2013, 12:56 PM
Replies: 1
Views: 439
Posted By mojo_jojoe4

2 different rim fitment questions

The first one is will these fit on my stock 91 all the way around? It says all 4 are rear fitment and I know the GTA rear was different than Firebird.
...
04-14-2013, 05:24 PM
Replies: 93
Views: 112,846
Posted By mojo_jojoe4

Re: Everything you ever wanted to know about wheels / fitment

All of these calculations confuse the heck out of me. Does anyone know if these would fit?

http://www.summitracing.com/parts/mbw-23199/overview/

Would they require adapters? I was looking at...
Forum: LTX and LSX
04-14-2013, 04:17 PM
Replies: 3
Views: 997
Posted By mojo_jojoe4

Re: LT1 conversion, won't start

Well, I got it running. I was right with my assumption and changed the cap, rotor, wires, and plugs and it fired right up. With it running rich, I just need to get it tuned now since it fouls plugs...
Forum: LTX and LSX
04-12-2013, 05:35 PM
Replies: 3
Views: 997
Posted By mojo_jojoe4

LT1 conversion, won't start

Ok, so I have had my car for about 12 years, 6 ish years ago I swapped out the 305TBI for a 350TPI, then put a converted LT1 intake and heads on it, 383 Lunati Short Block, Hooker Super Comps, 30lb...
Forum: Electronics
09-22-2012, 11:37 AM
Forum: Fabrication
07-04-2012, 09:44 PM
Replies: 11
Views: 5,857
Posted By mojo_jojoe4

Re: Custom Ram Air Box Fabrication - Ram Air II Hood - See Pics

That's pretty cool! How much did all that cost and how did you do it? What parts and how long did it take you? I'm looking to do something like that on mine.
Forum: Convertibles
05-09-2012, 11:57 AM
Replies: 0
Views: 631
Posted By mojo_jojoe4

Looking to find a vert I sold

I know this is a long shot, but I sold a 92 TA Vert back in 06-07 give or take. It was maroon, tan top, tan interior, gold honeycomb rims, had a 305 TPI, Auto, had GTA badges, even though I know it...
Forum: TPI
01-17-2005, 01:21 AM
Replies: 13
Views: 754
Posted By mojo_jojoe4

Do you have the harness and ECM? That is the...

Do you have the harness and ECM? That is the main things to get.
01-15-2005, 04:20 AM
Replies: 17
Views: 1,405
Posted By mojo_jojoe4

I am going to do this in the future. My mechanic...

I am going to do this in the future. My mechanic said that ported L98 heads would be good enough and a CC 306 cam with the LT1 converted intake. Go to Tracy Scott Performance...
01-04-2005, 06:24 AM
Replies: 157
Views: 7,977
Posted By mojo_jojoe4

Chris Farley drives a 2nd gen TA in the end of...

Chris Farley drives a 2nd gen TA in the end of one of his movies. I forget which one though.
01-03-2005, 06:53 AM
Replies: 10
Views: 545
Posted By mojo_jojoe4

305 TBI, better have got a good deal on the car.

305 TBI, better have got a good deal on the car.
Forum: Engine Swap
06-16-2003, 01:03 PM
Replies: 2
Views: 475
Posted By mojo_jojoe4

Yes I have searched, I have the harness for the...

Yes I have searched, I have the harness for the 350 TPI.
Forum: Engine Swap
06-16-2003, 10:18 AM
Replies: 2
Views: 475
Posted By mojo_jojoe4

305TBI to 350 TPI??

I bought an early L98 with the MAF setup I think it is 87. I have a 91 Firebird with the 305 TBI. I talked to our local Hot Rod shop and they said I can use my existing ECM do to the fact that it...
Forum: Convertibles
06-04-2003, 06:13 AM
Replies: 84
Views: 22,960
Posted By mojo_jojoe4

My car is originally red, but the guy I bought it...

My car is originally red, but the guy I bought it off of painted it purple, then two years later I was stupid and had it painted black, which looks like crap now b/c all you see in the chips is red. ...
Forum: Convertibles
06-03-2003, 12:23 PM
Replies: 84
Views: 22,960
Posted By mojo_jojoe4

I have a 91 Firbird Convertible with the L03 but...

I have a 91 Firbird Convertible with the L03 but there is an L98 out of a vette going in this week. I plan on making it look like the #27 Firehawk in 1992, mine was originally red and plan on...
Showing results 1 to 31 of 31


 
Forum Jump


All times are GMT -5. The time now is 12:11 AM.