Third Generation F-Body Message Boards

Search: Posts Made By: Nevada
Showing results 1 to 16 of 16
Search took 0.08 seconds.
Forum: Body
03-27-2006, 04:51 PM
Replies: 3
Views: 577
Posted By Nevada

door

i just put the door back on. the door position lever still mates with it ok. i out it all back together and the door still would not line up so i put my floor jack under the end of it and raised the...
Forum: Interior
03-26-2006, 11:16 PM
Replies: 545
Important/Useful : Seatbelt Recall
Views: 96,504
Posted By Nevada

recall

does the deal have the car info on whether the recall was done or not? my gas tank seems to leak when full. there was a recall on a gas line problem.
Forum: Body
03-26-2006, 08:29 PM
Replies: 3
Views: 577
Posted By Nevada

door hinge question

i have the door off and am ready to install the new lower hing pin. i have noticed that the door position post (not sure what to call it) on the body side hing bracket is worn. can this be replaced...
Forum: Electronics
03-22-2006, 07:27 PM
Replies: 2
Views: 687
Posted By Nevada

nope

i got it installed but nothing happened as before. when i went out about an hour later i found that the motor was very hot. i pulled the assembly and took it all apart so i can replace the vylon...
Forum: Electronics
03-22-2006, 04:51 PM
Replies: 2
Views: 687
Posted By Nevada

rear hatch pull down motor

Hi all,

I need some help troubleshooting my rear hatch pull down motor. I have it installed. I am getting power to the unit. It did nothing when I first put it in until I touched the motor...
Forum: Tech / General Engine
03-10-2006, 10:46 PM
Replies: 5
Views: 618
Posted By Nevada

thx

ok thx guys. sounds like a plan. i will look at teh IAT as well. thx for the link!

nevada
Forum: Tech / General Engine
03-10-2006, 09:25 PM
Replies: 5
Views: 618
Posted By Nevada

thx! another question

this is the error - does this mean the map sensor is bad or the EGr is bad?

EGR open command did not change the MAP sensor signal. Normal EGR flow should cause slight decrease in manifold vacuum...
Forum: Tech / General Engine
03-10-2006, 04:16 PM
Replies: 5
Views: 618
Posted By Nevada

engine code question

i read out the codes on my 1990 305 TBI 5spd.

here is what i got:

23. Low temperature at manifold air temperature sensor OR
Throttle position sensor error.

32. Fault in barometric...
Forum: Body
02-26-2006, 08:13 PM
Replies: 10
Views: 3,915
Posted By Nevada

thx guys

the pictures look like the one i pulled. i cleaned it up and greased. seems to be working great now. nex i need to find a pull down motor for the rear hatch. the bone yard only had one but it used a...
Forum: Body
02-26-2006, 04:45 PM
Replies: 10
Views: 3,915
Posted By Nevada

also

i paid 600 for it and i think it is good shape. no rust and no accidrnts as far as i can tell. the better half swears its a piece a crap so i have to prove here wrong now. if i dont i will have to...
Forum: Body
02-26-2006, 04:43 PM
Replies: 10
Views: 3,915
Posted By Nevada

hehehe

No (that would be funny though), I was adjusting the little rubber deals under the hood so I could line the hood up with the fenders so everything looked squared. It turns out the neighbor kid is...
Forum: Body
02-26-2006, 03:19 PM
Replies: 10
Views: 3,915
Posted By Nevada

i have got a huge problem i think

i bought a 90 rs for 600 bones. in good shape. the hood latch was bad so i bought one at thebone yard and installed. everything was working great while testing the latch. after testing i dropped the...
Forum: Body
02-26-2006, 01:43 AM
Replies: 7
Views: 683
Posted By Nevada

thx

thx for the info and the site link. i am a little confused however. i do not have a switch in the console or dash to work the hatch. was the pull down motor also on cars without this? i am wondering...
Forum: Body
02-25-2006, 02:26 PM
Replies: 7
Views: 683
Posted By Nevada

cost

what do you think one from the bone yard is worth with the motor?
Forum: Body
02-25-2006, 02:25 PM
Replies: 7
Views: 683
Posted By Nevada

pull down

Hey all,

I do not seem to have the motor part. There is no motor attached the latch mechanism. There seems to be a relay and some connectors there for one though. I also do not have the switch on...
Forum: Body
02-23-2006, 04:44 PM
Replies: 7
Views: 683
Posted By Nevada

rear latch loose - not sure how it mounts

hi all,

i just picked up a 1990 RS (first camaro). the rear hatch latch is loose. is looks like it slides into a bracket mounted to the body but there does not seem to be anything that holds it in...
Showing results 1 to 16 of 16


 
Forum Jump


All times are GMT -5. The time now is 03:47 PM.