Third Generation F-Body Message Boards

Search: Posts Made By: thomeygun1
Showing results 1 to 24 of 24
Search took 0.09 seconds.
Forum: Exhaust
02-16-2009, 07:16 PM
Replies: 7
Views: 889
Posted By thomeygun1

Re: any one have a borla muffler.

i have a borla on my car and it is mellow at idle...it really comes alive though at deep throttle...it sounds nothing like a flowmaster
Forum: TPI
09-04-2008, 07:54 PM
Replies: 3
Views: 419
Posted By thomeygun1

Re: Vortec head selection

Im pretty sure its two The description on the page before that uses the word "heads" and the weight says 115lbs and im almost positive one head doesnt weigh that.

I already have a skoggin dickey...
Forum: TPI
09-03-2008, 01:55 PM
Replies: 3
Views: 419
Posted By thomeygun1

Vortec head selection

I have finally saved up enough money for a new set of heads and im going to go with the vortec design. 800 dollars is the most i can spend on them and i was woundering who makes the best flowing...
Forum: TPI
05-28-2008, 10:00 PM
Replies: 22
Views: 9,347
Posted By thomeygun1

Re: TPI Stumbling Under Light Throttle

your tps sensor could be bad or might jus need adjusted
Forum: TPI
05-14-2008, 06:03 PM
Replies: 15
Views: 2,291
Posted By thomeygun1

Re: I need fuel Injector retainer clips

it also depends on what kind of injectors you have if you need the clips or not b/c my venom injectors wouldnt work w/o the clips
Forum: TPI
05-14-2008, 05:57 PM
Replies: 5
Views: 578
Posted By thomeygun1

Re: Cars missing & #5 plug is wet

well i pulled the valve cover off and everything is fine...

i guess jegs will be getting a call tomorrow
Forum: TPI
05-14-2008, 12:03 PM
Replies: 5
Views: 578
Posted By thomeygun1

Re: Cars missing & #5 plug is wet

my wires are brand new moroso wires and i tried a couple of my old accel wires...

ill check my fuel pressure se if it bleeds down fast after i turn it off

i'm going to pop my valve cover off...
Forum: TPI
05-12-2008, 07:52 PM
Replies: 19
Views: 2,996
Posted By thomeygun1

Re: TPS readings?

i believe the MAF TPS sensor should read .54V closed throttle and should go up over 4.5V at WOT
Forum: TPI
05-12-2008, 07:17 PM
Replies: 5
Views: 578
Posted By thomeygun1

Cars missing & #5 plug is wet

I have just recently put 24lb venom injectors in my 91 TPI 350 TA to replace my factory injectors and the car ran great for about three or four days...

Then i noticed that my car had a miss to it...
Forum: TPI
05-05-2008, 11:08 AM
Replies: 17
Views: 12,022
Posted By thomeygun1

Re: HELP car dies when given gas

So i replaced my injectors this past weekend and it turned out to be the problem...i took your guys advice and went with 24lb injectors...that bad injector was probably stuck closed and when i gave...
Forum: TPI
04-26-2008, 07:57 PM
Replies: 17
Views: 12,022
Posted By thomeygun1

Re: HELP car dies when given gas

alright i dont think im going 30lb injectors...i think i will go with the 26lb venoms
Forum: TPI
04-23-2008, 02:57 PM
Replies: 17
Views: 12,022
Posted By thomeygun1

Re: HELP car dies when given gas

the engine will be modded some for now..

it has a cam with i believe 270/280 duration and like .460/.474 lift im not sure exactly i dont have the cam card on me right now and im also putting the...
Forum: TPI
04-22-2008, 07:39 PM
Replies: 17
Views: 12,022
Posted By thomeygun1

Re: HELP car dies when given gas

im just going to replace all the injectors with 30lb bosch injectors..

would these be ok for a while until i get my computer tuned?
----------...
Forum: TPI
04-21-2008, 02:21 PM
Replies: 17
Views: 12,022
Posted By thomeygun1

Re: HELP car dies when given gas

i ran a test on my injectors here are the results
... 1:13.3 5:16.8
2:1.9 6:16.9
3:16.8 7:16.8
4:14.4 8:16.9 Ohms

is this my problem..would a couple of...
Forum: TPI
04-17-2008, 10:55 AM
Replies: 17
Views: 12,022
Posted By thomeygun1

Re: HELP car dies when given gas

its not the fpr cus i replaced that the day it started acting up.

yea i wasnt getting any black smoke...but a blockage in the fuel rails does make sense...

i might jus swap in my slp runners...
Forum: TPI
04-17-2008, 09:00 AM
Replies: 17
Views: 12,022
Posted By thomeygun1

Re: HELP car dies when given gas

well the pressure is right around 46PSI when running and around 48PSI when just the ignition is on..

Cleaning the throttle body was actually one of the first things i did but it didnt help...
...
Forum: TPI
04-16-2008, 09:28 PM
Replies: 17
Views: 12,022
Posted By thomeygun1

Re: HELP car dies when given gas

i dropped the fuel pressure down to 47 PSI adjusted the IAC it didnt work the car stil dies out at the touch of the throttle..

would a stuck injector cause this big of a problem?
Forum: TPI
04-16-2008, 08:25 AM
Replies: 17
Views: 12,022
Posted By thomeygun1

Re: HELP car dies when given gas

it is a 350TPI..i have the fuel pressure set at 50 PSI with the switch on and when you start it the PSI drops a little..

and i know that the TPS is set corrrectly im not quite sure about how to...
Forum: TPI
04-15-2008, 09:19 PM
Replies: 17
Views: 12,022
Posted By thomeygun1

HELP car dies when given gas

i have a 91 TA...when i first turn it on it starts up and idles rough but when i give it gas its like it hits a wall and jus dies out..when initially started you can rev it to about thirty two grand...
Forum: TPI
01-28-2008, 10:49 PM
Replies: 2
Views: 421
Posted By thomeygun1

Car bogs around 3700 RPM

i have a 91 TA and when i floor my car it starts to bog around 3900 RPM. if i dont floor it all the way it will go up to 5000 RPM though..also my check engine light comes on and off occasionally...
Forum: Engine/Drivetrain/Suspension Parts for Sale
12-02-2007, 08:31 PM
Replies: 27
Views: 1,590
Posted By thomeygun1

Re: Complete Vortec TPI setup (SC)

is this setup for a 90-92 tpi
Forum: Engine/Drivetrain/Suspension Parts for Sale
11-21-2007, 03:09 AM
Replies: 52
Views: 2,808
Posted By thomeygun1

Re: tpi set up edelbrock,slp,ported plenum

my bizzle i missed that part
Forum: Engine/Drivetrain/Suspension Parts for Sale
11-19-2007, 01:55 PM
Replies: 52
Views: 2,808
Posted By thomeygun1

Re: tpi set up edelbrock,slp,ported plenum

What year tpi is this stuff
Forum: Car Audio
08-20-2007, 03:33 PM
Replies: 3
Views: 655
Posted By thomeygun1

bad ground?

i just recently put subs and an amp in my 91 ta. as soon as i turn the stereo on the subs make a constant thumping sound is this a bad ground or a bad connection somewhere?? any help is appreciated...
Showing results 1 to 24 of 24


 
Forum Jump


All times are GMT -5. The time now is 05:51 AM.