Third Generation F-Body Message Boards

Search: Posts Made By: bruhthakuga
Showing results 1 to 7 of 7
Search took 0.06 seconds.
Forum: Tech / General Engine
07-29-2013, 07:29 AM
Replies: 11
Views: 1,460
Posted By bruhthakuga

constriction in return fuel flow

! ! UPDATE ! !

I check the fuel pressure and it was good at 10psi, the specs in the Chilton Manuel said that the pressure should be within 9 to 13.

I did though find something of note, the...
Forum: Tech / General Engine
07-24-2013, 08:53 PM
Replies: 11
Views: 1,460
Posted By bruhthakuga

Re: Persistent Loping Idle

I just returned from AutoZone renting a kit for testing fuel and one for compression. After those test I will remove inspect and reinstall both the IAC and TPS, then reset IAC idle speed.
Forum: Tech / General Engine
07-23-2013, 03:46 PM
Replies: 11
Views: 1,460
Posted By bruhthakuga

Re: Persistent Loping Idle

I made sure to route and zip tie plug wires away from heat B U T.. .. .. I will check anyway. About those thermal sleeve & boots, I am going to look into them.
Forum: Tech / General Engine
07-22-2013, 08:20 PM
Replies: 11
Views: 1,460
Posted By bruhthakuga

Re: Persistent Loping Idle

Loping isn't always misfiring, Worn timing chain and gears cause loping and my lope is similar only I have new chain and gears also new distributor cap & rotor, plugs & wires, even a new ignition...
Forum: Tech / General Engine
07-19-2013, 12:24 AM
Replies: 11
Views: 1,460
Posted By bruhthakuga

Re: Persistent Loping Idle

All engine management/emission parts are new, I checked and found no vac leaks, firing order is correct. The truck was as is when I got it for a project. It runs smooth in drive, all pistons fire. I...
Forum: Tech / General Engine
07-16-2013, 05:48 AM
Replies: 11
Views: 1,460
Posted By bruhthakuga

Persistent Loping Idle

Friends, I have a loping idle on my '90 GMC C1500 5.7TBI. All engine management parts are new. It's smooth in drive though. I followed the suggestion by Tom Keliher in his article here on ThirdGen at...
Forum: Electronics
08-05-2007, 05:11 PM
Replies: 15
Views: 22,810
Posted By bruhthakuga

Viper 791XV

I just finished the wiring of my Viper 791XV, well almost, I have all the nessassary alarm wires connected, I don't have the Remote Start Wires connected and the Additional Optional Relays wires...
Showing results 1 to 7 of 7


 
Forum Jump


All times are GMT -5. The time now is 06:59 AM.