Motor mounts in correct spot?
06-08-2008, 10:48 PM
#1
Junior Member
Thread Starter
iTrader: (5)
Join Date: Oct 2007
Location: Lenexa, KS
Posts: 81
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1984 Pontiac Trans Am
Engine: LG4 305 V8
Transmission: 700R4
Axle/Gears: 10-bolt LSD
Motor mounts in correct spot?
This might be a stupid question, but did I put the motor mounts back on the K-member in the right spot? It's been a while since it was on the car and had an engine there, but it seemed odd to have that one tab hanging off the front edge. I checked several variations of how the mounts might fit, and only found one way that the bolt holes line up.
Hardware is 7/16" grade 8 for the mount to K-member bolts and 1/2" for the bracket to mount bolts. Mount material is Prothane poly.
Hardware is 7/16" grade 8 for the mount to K-member bolts and 1/2" for the bracket to mount bolts. Mount material is Prothane poly.
06-08-2008, 11:10 PM
#2
Member
Join Date: Feb 2008
Location: Summerland, B.C
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1982 Trans am
Engine: 383
Transmission: AGE M22Z
Axle/Gears: Moser 9" 3.70 detroit locker
Re: Motor mounts in correct spot?
Ya you have them in the right spot. Its normal for that tab to hang off the front edge.
06-09-2008, 09:10 AM
#3
Junior Member
Thread Starter
iTrader: (5)
Join Date: Oct 2007
Location: Lenexa, KS
Posts: 81
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1984 Pontiac Trans Am
Engine: LG4 305 V8
Transmission: 700R4
Axle/Gears: 10-bolt LSD
Re: Motor mounts in correct spot?
Thanks! As soon as the engine compartment gets some paint, it is going back in.
Thread
Thread Starter
Forum
Replies
Last Post
NBrehm
Engine/Drivetrain/Suspension Parts for Sale
0
08-05-2015 07:57 PM