Car starts now!!! One last question.
#1
Supreme Member
Thread Starter
Join Date: Jul 2000
Location: Tomball, TX
Posts: 1,787
Likes: 0
Received 20 Likes
on
16 Posts
Car: 89 TTA
Engine: Turbo 3.8
Transmission: 200R4
Car starts now!!! One last question.
Ok, I put in my spare ignition module (orginal) that a had a few weeks ago and now it's not giving me any starting trouble at all. I didn't have an dielectric grease to use so I just put the thing on there. The thing the car is doing now is at idle it sometimes falls out like down to 400 RPM or so then goes back up around 700 where it normally is. I think it's the module that's just old or not getting a good connection. Anybody that would like to agree or disagree?
#5
Supreme Member
Join Date: Sep 1999
Location: Ewing, NJ
Posts: 2,175
Likes: 0
Received 0 Likes
on
0 Posts
you may want to try to back teh timing off a touch too, if the timing is a bit too far ahead it can cause the engien to sort of load up at idle and not sit smoothly in place.
if that doesn't help, how old is your O2 sensor? that could make the car run rich at idle.
hope this helps
tim
if that doesn't help, how old is your O2 sensor? that could make the car run rich at idle.
hope this helps
tim
#6
Supreme Member
iTrader: (1)
Join Date: Jul 2001
Location: Maple Shade, NJ
Posts: 1,509
Likes: 0
Received 0 Likes
on
0 Posts
my car does the same recently. It will shake a little under 900 rpms. I changed the O2 sensor and it does it still. SO, adjusted timing. With the wire disconnected it idled fine, when I reconnected it after the timing was set, it shakes again. I DONT GET IT.
Thread
Thread Starter
Forum
Replies
Last Post
Iroc8t8
TPI
43
08-26-2015 08:14 AM
db057
TBI
10
08-11-2015 10:11 PM