can u guys help w/ this problem?
#1
Member
Thread Starter
Join Date: Mar 2005
Location: lexington, ky
Posts: 451
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 camaro 305 tbi
Engine: 305 tbi l03
Transmission: 700r4
can u guys help w/ this problem?
i know this dosent go here and i tried getting help in the electronics board but im gettin no answers over there and u guys always seem to help me out if you could take a look at this and tell me what u think
https://www.thirdgen.org/techbb2/sho...hreadid=324064
https://www.thirdgen.org/techbb2/sho...hreadid=324064
#2
Member
Join Date: Aug 2005
Location: Ct valley
Posts: 177
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 TA
Engine: TBI 5.7
Transmission: 700R4
yes i think i can help you out. all you need is the switch and some wire. the fan relay you have has a dark green wire white stripe (not sure thats the wire hanes manual says, ill look at my car tomarrow0. tap into that wire and run it to your switch. wire switch to ground and you done. if its a lighted switch it wont light, but it works.
hope this helps.
hope this helps.
#3
TGO Supporter
iTrader: (3)
https://www.thirdgen.org/newdesign/tech/cool.shtml
This should fix you up
Also there is a section on this board for cooling systems
This should fix you up
Also there is a section on this board for cooling systems
#4
Member
Join Date: Aug 2005
Location: Ct valley
Posts: 177
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 TA
Engine: TBI 5.7
Transmission: 700R4
ok so i looked at the relay on my car. the activation wire is green with white strip. this is the wire that goes to the fan switch on your head. if you tap into this wire and attach it to ground through the switch. this is how i have it on my car. it allows you to turn the fan on by the switch or if you leave the switch off it will work normal
#5
Member
Thread Starter
Join Date: Mar 2005
Location: lexington, ky
Posts: 451
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 camaro 305 tbi
Engine: 305 tbi l03
Transmission: 700r4
beautiful so i wire one hot to the switch one hot to the fan relay and one ground to the switch? cause theres three terminals i belive although im at work and not exactly positive....thanks for all the help though ill get to work on that this weekend when i try and wire up this tach. and as for the cooling board next time i will post there i was just torn because this deals w/ wiring up somethin so i wasnt sure which one would be better
#6
Member
Join Date: Aug 2005
Location: Ct valley
Posts: 177
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 TA
Engine: TBI 5.7
Transmission: 700R4
the one green wire is hot so you dont need to run a hot wire. just tap into the green one and run that wire to your switch. Then from the other terminal of the switch to ground. you can use a lighted switch but you wont beable to get it to light because your not on the positive side of the circuit.
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
05-17-2020 10:44 AM
HoosierinWA
Tech / General Engine
5
10-07-2015 10:15 AM