Bored Throttle Body with working Balance port
02-12-2008, 08:24 AM
#1
Bored Throttle Body with working Balance port
One of my more challenging projects was to bore a Crossfire TB to 2" and 2.125" while retaining the ability to properly balance them.
First picture is completed 2" bored prototype puling 6" water on manometer:
Second picture is first prototype in progress. Note balance hole:
First picture is completed 2" bored prototype puling 6" water on manometer:
Second picture is first prototype in progress. Note balance hole:
02-14-2008, 07:41 AM
#3
Re: Bored Throttle Body with working Balance port
If you mean the top picture, then those are chrome powder coated.
The bottom picture is carb cleaner followed by light abrasive blast in prep for powder.
The bottom picture is carb cleaner followed by light abrasive blast in prep for powder.
Thread
Thread Starter
Forum
Replies
Last Post
Terrell351
Engine/Drivetrain/Suspension Parts for Sale
5
06-13-2021 01:13 PM
Fast355
DFI and ECM
14
12-02-2016 06:33 PM
