projectRS92

i need to put new intake manifold in 92rs tbi but all the one i see dont mach up.. they dont look like the stock one dont know if my stock tbi set up will bolt up to this one let me know if so ..our there is a better one what will work just not sure if my tbi will fit on that

Ronny

iTrader: (1)

You need an adapter for a carb intake. Holley and Edelbrock sell direct replacements(TBI).

projectRS92

or this will be a batter idea and fit and thanks for letting me know

projectRS92

looked Holley Performance TBI Adapter not sure witch one is right one to get there are different can u show me witch on would work or should i go with the tbi intake manifold i posted

Ronny

iTrader: (1)

The pic you showed is only a bit better than stock. Holley is good to 6500 rpms so they say. My Holley has seen 6000 rpms but it or my 7.4L TB(with inj pods) is a slight restriction.

projectRS92

http://static.summitracing.com/globa...3704_JY_ml.jpg this one right and can u show me what adapter i should use if i go with the non tbi manifold

Ronny

iTrader: (1)

Summit maybe sells the adapter. I bought mine from Howell Engineering but never used it and returned it. It was .50 inch thick and 2.00 in bore.

projectRS92

so this one will work right with out the adapter

projectRS92

so this one will work with out the adapter ?

projectRS92

this is what i would need and would it fit under a stock hood

Ronny

iTrader: (1)

I believe so. small block chevy has two choices one being vortec.

projectRS92

[QUOTE=projectRS92;5619510] this is what i would need and would it fit under a stock hood

Ronny

iTrader: (1)

Not sure on stock hood. you would need to measure with play dough or modeling clay. I went to Howell since it was a 2.00 bore and .50 inch high. I also owned a single plane that was machined down to minimum for more clearance(vett hood). Never used. Now I wish I had given it a try and had it machined for port fuel.

projectRS92

thanks a lot for the help know i have to make up my mind on with one to do