What the hell is up with the Wells' MAF?!?!
05-21-2001, 01:38 PM
#1
Junior Member
Thread Starter
Join Date: Oct 2000
Location: Coppell, TX
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
What the hell is up with the Wells' MAF?!?!
I have called six parts stores here in Dallas and all of them said the same thing, "I wont touch wells with a 10 foot pole!" So what is the deal with these guys are their parts bad quality or something. I can get a Bosch replacement from TPIS for 249.00 and wanted to know what you guys think I should do?
05-21-2001, 02:07 PM
#2
Member
Join Date: Jan 2000
Location: San Diego, CA
Posts: 183
Likes: 0
Received 0 Likes
on
0 Posts
In the power adder board someone posted something about a wiring harness being available so you can use a ford MAF on TPI. If my MAF ever goes that is what I am doing. The ford ones can be picked up used all over the place for a few bucks... and you can upgrade to a larger MAF too. I wonder how expensive the harness is tho.
05-21-2001, 09:04 PM
#4
Supreme Member
Join Date: Jan 2001
Location: PA
Posts: 1,978
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 Firebird WS6
Engine: 350 TPI
Transmission: T56
Axle/Gears: 3.42
You could get them alot cheaper than that though.... I got a remanufactured bosche MAF from a local (Cee-Kay) part store for about $100.
05-22-2001, 01:14 AM
#5
Member
iTrader: (1)
Join Date: May 2001
Location: So Cal / El Mirage, AZ
Posts: 332
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 Z28
Engine: 350 TPI
Transmission: 700R4
Axle/Gears: 3.23
Look here:
https://www.thirdgen.org/messgboard/...ML/002095.html
I just ordered one today and they told me I should have it by Friday.
https://www.thirdgen.org/messgboard/...ML/002095.html
I just ordered one today and they told me I should have it by Friday.
Thread
Thread Starter
Forum
Replies
Last Post