07-30-2006, 02:44 AM
|
#1 |
| Senior Member
Join Date: Mar 2005 Location: Hamilton
Posts: 1,171
Car: 1990 IROCZ Camaro Engine: 350 4bbl, 200cc Heads, 270hr Cam Transmission: 700R4 w/ Trans-Go shift kit. Axle/Gears: GM 10 bolt Posi | Issues with new timing chain & gears
Need help fast, as I need this car running by tuesday.
Doing cam and heads, and all is going well so far.
I took off the timing chain cover and came to find out when I got the cam gear and chain removed that my Cloyes double roller chain and gear set (CLO-C3023) is a little different than my stock one. Seems that it is a tad wider and will not clear the cover. It might though, I am not sure, it will be close. Did I pick up the wrong set? It says "For non factory roller cam motors", and I read this as "I have a roller cam motor, but the cam is aftermarket" and thought this was the right part.
Anyone else use this gear set? Whats my issue here?
| | |
__________________ 
355ci / 4bbl Holley 750cfm Carburetor / Edelbrock Performer RPM / Brodix IK200 Aluminum Heads / Comp XR270HR-10 Cam / ProComp HEI Distributor / Trans-Go Shift Kit / Powerstick Chambered Muffler / Summit Shorty Headers / Flowtec Y-Pipe / !Smog / !A/C
|
 
|  |
