Issues with new timing chain & gears
Thread Starter
Supreme Member
iTrader: (1)
Joined: Mar 2005
Posts: 1,171
Likes: 0
From: Hamilton
Car: 1990 IROCZ Camaro
Engine: 350 4bbl, 200cc Heads, 270hr Cam
Transmission: 700R4 w/ Trans-Go shift kit.
Axle/Gears: GM 10 bolt Posi
Issues with new timing chain & gears
Need help fast, as I need this car running by tuesday.
Doing cam and heads, and all is going well so far.
I took off the timing chain cover and came to find out when I got the cam gear and chain removed that my Cloyes double roller chain and gear set (CLO-C3023) is a little different than my stock one. Seems that it is a tad wider and will not clear the cover. It might though, I am not sure, it will be close. Did I pick up the wrong set? It says "For non factory roller cam motors", and I read this as "I have a roller cam motor, but the cam is aftermarket" and thought this was the right part.
Anyone else use this gear set? Whats my issue here?
Doing cam and heads, and all is going well so far.
I took off the timing chain cover and came to find out when I got the cam gear and chain removed that my Cloyes double roller chain and gear set (CLO-C3023) is a little different than my stock one. Seems that it is a tad wider and will not clear the cover. It might though, I am not sure, it will be close. Did I pick up the wrong set? It says "For non factory roller cam motors", and I read this as "I have a roller cam motor, but the cam is aftermarket" and thought this was the right part.
Anyone else use this gear set? Whats my issue here?
Thread Starter
Supreme Member
iTrader: (1)
Joined: Mar 2005
Posts: 1,171
Likes: 0
From: Hamilton
Car: 1990 IROCZ Camaro
Engine: 350 4bbl, 200cc Heads, 270hr Cam
Transmission: 700R4 w/ Trans-Go shift kit.
Axle/Gears: GM 10 bolt Posi
Originally Posted by ede
you have the wrong part, you have a factory roller
Thread
Thread Starter
Forum
Replies
Last Post
