just checking - 350 with 5 speed - starter
#1
Member
Thread Starter
iTrader: (1)
Join Date: Feb 2007
Location: Spring, TX
Posts: 489
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 Bird
Engine: TPI 350
Transmission: 5-Speed
Axle/Gears: 2.77 posi
just checking - 350 with 5 speed - starter
Just cranked my TPI 350. I used the 5 speed that was behind the 305.
I am getting a little grinding at the starter when I first hit the key.
Will the starter for the 305 5 speed work on the 350 (yes it does bolt on)? Do I need to modify anything other than possibly shims?
flywheel was same tooth count and size as flexplate. 700r4 starter doesn't fit the 5 speed bellhousing. Had to use the smaller starter from the 5 speed.
This seems to be the only problem and troubleshooting so far with the swap.
I am getting a little grinding at the starter when I first hit the key.
Will the starter for the 305 5 speed work on the 350 (yes it does bolt on)? Do I need to modify anything other than possibly shims?
flywheel was same tooth count and size as flexplate. 700r4 starter doesn't fit the 5 speed bellhousing. Had to use the smaller starter from the 5 speed.
This seems to be the only problem and troubleshooting so far with the swap.
#2
Supreme Member
Join Date: Oct 2006
Posts: 1,974
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 RS
Engine: 350 vortec
Transmission: T-5
Axle/Gears: not the best not the worst
Re: just checking - 350 with 5 speed - starter
as long as you are using all 153 tooth stuff you shouldnt have any problem with compatability you just need to play with some shims
#3
Member
Join Date: Feb 2008
Location: Summerland, B.C
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1982 Trans am
Engine: 383
Transmission: AGE M22Z
Axle/Gears: Moser 9" 3.70 detroit locker
Re: just checking - 350 with 5 speed - starter
I would try some putting shims in. if it bolts up and turns the motor it should work.
Thread
Thread Starter
Forum
Replies
Last Post
mhatfield 14
Tech / General Engine
5
10-24-2015 07:48 AM
db057
TBI
10
08-11-2015 10:11 PM