AFR 195 Eliminator Spring Pocket
#1
Member
Thread Starter
iTrader: (2)
Join Date: Apr 2002
Location: louisville, co
Posts: 372
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 T/A
Engine: 383
Transmission: 700R4
Axle/Gears: 3.27 9 bolt
AFR 195 Eliminator Spring Pocket
Will these spring seats fit the AFR part# 1038's, or do I even need a spring seat/cup?
http://www.airflowresearch.com/produ...roducts_id=112
They originally came equipped with 1.29" outside diameter valve springs, and I will be installing some comp part# 950-16's that are 1.464". My battery on my dial caliper died but using the ruler part it looks like the spring pocket is right at 1.5". So it will be a real snug fit, is this too snug? The AFR spring seats linked above are 1.550".
http://www.airflowresearch.com/produ...roducts_id=112
They originally came equipped with 1.29" outside diameter valve springs, and I will be installing some comp part# 950-16's that are 1.464". My battery on my dial caliper died but using the ruler part it looks like the spring pocket is right at 1.5". So it will be a real snug fit, is this too snug? The AFR spring seats linked above are 1.550".
#2
Supreme Member
Re: AFR 195 Eliminator Spring Pocket
It should work fine. AFR offers some spring packages with springs up in the 1.50" range and they're sitting in the same spring pockets as every other package they sell.
Whatever shims you are using to dial in the installed height go UNDER that hardened seat.
Whatever shims you are using to dial in the installed height go UNDER that hardened seat.
Thread
Thread Starter
Forum
Replies
Last Post
Glowsock
Tech / General Engine
2
09-11-2015 11:09 PM