More Engine Help...0psi Compression
#1
More Engine Help...0psi Compression
Hello again guys,
So after I finally put a new crank in with matched bearings, with around .0015-.0020 on rods and mains according to plastigage. Now all the engine does is turn over. Has gas, has spark. Doesn't even try to start. No compression. Literally. 0 frickin psi in #1 cylinder, and I'm assuming in the rest as well. What in the hell could cause this? Engine had low oil pressure because I forgot the galley plugs, do I need to reset valve lash? I bought a new timing gear and set it at the special "magical" 4* advance the box recommends I do...lined up the dots etc. What is going on?
Thanks in advance for the advice and for listening to my whining
So after I finally put a new crank in with matched bearings, with around .0015-.0020 on rods and mains according to plastigage. Now all the engine does is turn over. Has gas, has spark. Doesn't even try to start. No compression. Literally. 0 frickin psi in #1 cylinder, and I'm assuming in the rest as well. What in the hell could cause this? Engine had low oil pressure because I forgot the galley plugs, do I need to reset valve lash? I bought a new timing gear and set it at the special "magical" 4* advance the box recommends I do...lined up the dots etc. What is going on?
Thanks in advance for the advice and for listening to my whining
#2
Supreme Member
iTrader: (1)
Join Date: Sep 2005
Posts: 26,177
Received 1,704 Likes
on
1,296 Posts
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: More Engine Help...0psi Compression
Sound slike the valves are all too tight.
Back em all off 3 turns and try again.
Back em all off 3 turns and try again.
#3
Re: More Engine Help...0psi Compression
In case like me didn't remember your thread from before..................
https://www.thirdgen.org/forums/tech...d-low-oil.html
https://www.thirdgen.org/forums/tech...d-low-oil.html
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
03-05-2017 06:37 PM
NinjaNife
Tech / General Engine
27
08-23-2015 11:49 AM