4.3L 90 degree V6 build
04-04-2013, 07:47 PM
#1
Supreme Member
Thread Starter
iTrader: (2)
Join Date: Jul 2009
Location: morrow, ga
Posts: 1,354
Likes: 0
Received 4 Likes
on
4 Posts
Car: 82 S10, 83 280ZX, 84 Z28
Engine: 355 smallblocks..na, 2.8 turbo
Transmission: 85:th350, 84:700R4
Axle/Gears: 85:ford9 4.85, 84:stock 3.24
4.3L 90 degree V6 build
I'm rebuilding my first 4.3L V6. I've done tons of 5.7L V8s. This one came out of a 1996 GMC jimmy SFI vortec. I've noticed the parts are a lot more expensive for this engine and like everyone I'm trying to save money. I'd like to know if there are any interchangeable parts between the two. If the rings and bearings are the same I'll just get a 5.7L kit and have some leftover parts. Thanks
04-04-2013, 11:39 PM
#2
Supreme Member
Join Date: Jul 2011
Posts: 2,529
Likes: 0
Received 0 Likes
on
0 Posts
Re: 4.3L 90 degree V6 build
04-05-2013, 02:22 AM
#3
Supreme Member
Thread Starter
iTrader: (2)
Join Date: Jul 2009
Location: morrow, ga
Posts: 1,354
Likes: 0
Received 4 Likes
on
4 Posts
Car: 82 S10, 83 280ZX, 84 Z28
Engine: 355 smallblocks..na, 2.8 turbo
Transmission: 85:th350, 84:700R4
Axle/Gears: 85:ford9 4.85, 84:stock 3.24
Re: 4.3L 90 degree V6 build
Thanks for the link. I just finished reading it. It's interesting how different the 4.3L actually is from the 5.7L. Also interesting how some parts within the 4.3L family wont interchange just because the were built in two different assembly plants.
Thread
Thread Starter
Forum
Replies
Last Post
