Exhaust wire looms
05-01-2014, 05:39 AM
#1
Junior Member
Thread Starter
Join Date: Jan 2012
Location: Brisbane, Australia
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 Z28
Engine: 5.0 LG4
Transmission: 4L60 (Built)
Axle/Gears: 3.23 Eaton TrueTrac
Exhaust wire looms
Anyone know what the thread size is for the wire loom holders that bolt into "G" are? I bought some Moroso wire looms and they didn't come with bolts 
05-01-2014, 07:06 AM
#2
Supreme Member
Re: Exhaust wire looms
1/4"-20.
I have the Moroso looms as well.
It was necessary to clearance the header (in my case). I also made a spacer (out of 5/16" nut) to stand the loom away from the head as it's needed to clear the header.
I made the installation a little and used a socket head cap screw as opposed to a conventional hex head bolt.
I have the Moroso looms as well.
It was necessary to clearance the header (in my case). I also made a spacer (out of 5/16" nut) to stand the loom away from the head as it's needed to clear the header.
I made the installation a little and used a socket head cap screw as opposed to a conventional hex head bolt.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM
Street Lethal
Power Adders
634
04-30-2019 12:14 PM
eightsixseven
Tech / General Engine
1
08-14-2015 03:09 PM