accessory bolt holes
12-01-2018, 09:55 PM
#1
Senior Member
Thread Starter
Join Date: Mar 2007
Location: Muscatine IA
Posts: 574
Likes: 0
Received 2 Likes
on
2 Posts
Car: 91 Firebird Formula
Engine: 383
Transmission: built 700r4
Axle/Gears: 4.11, 9inch
accessory bolt holes
allright this is going to sound like a stupid question. ive got a line on a 350 to swap into my camaro. but its only got one accessory bolt hole on the passenger side head. (upper hole on header side of head) question is which holes do I need for a v belt set up on a thirdgen.
12-01-2018, 10:04 PM
#2
Re: accessory bolt holes
Any holes you need can be drilled and tapped easily. I added a hole on my 86 305 for serpentine belt swap. No problem. Just properly locate the hole with a transfer punch and make sure you use thread sealant. I like Loctite 545 personally. Really isn't an issue - the head bolts themselves extend right into the block water passages and must use sealant also.
And if you are swapping engines - PLEASE put on the serp system. It works really, really good. No belt noises ever again!
GD
And if you are swapping engines - PLEASE put on the serp system. It works really, really good. No belt noises ever again!
GD
Thread
Thread Starter
Forum
Replies
Last Post
cort351w
Suspension and Chassis
14
01-10-2003 07:10 PM
nichoulas83Z454
Tech / General Engine
3
08-08-2002 02:01 AM