routing vacuum hoses, have modified diagram...
#1
Member
Thread Starter
Join Date: Apr 2002
Location: Edison, NJ
Posts: 276
Likes: 0
Received 0 Likes
on
0 Posts
routing vacuum hoses, have modified diagram...
Have 2 problems, I think they are vac lines, but dont show up on the diagram, so I moddified the diagram, hopefully someone can tell me where they go...
The circle is a canister type thing looks like its connected to the coolant hoses...
The line (broken on car) connects to the back of the plenem and connects to what I believe is the cruise control.
Do these connect together?? If not any idea as to where they go??
BTW 88 GTA 5.7
The circle is a canister type thing looks like its connected to the coolant hoses...
The line (broken on car) connects to the back of the plenem and connects to what I believe is the cruise control.
Do these connect together?? If not any idea as to where they go??
BTW 88 GTA 5.7
#5
Supreme Member
iTrader: (3)
Join Date: Jan 2001
Location: Conroe, TX
Posts: 3,167
Received 54 Likes
on
40 Posts
Car: 1987 GTA
Engine: LS1
Transmission: 4L60e
Point out what you want me to investigate ( I can't read your diagram very well) and I'll go dig around awhile. Everything's a little compressed on my car right now
Trending Topics
#11
Supreme Member
That's the heater control valve. I think this line runs to the heater controls inside the car, or to a vacuum manifold related to the heater controls.
#12
Member
Thread Starter
Join Date: Apr 2002
Location: Edison, NJ
Posts: 276
Likes: 0
Received 0 Likes
on
0 Posts
and this one, before for some reason I couldnt post??!??
Any definate answers as to where they go, pics would be supurb, THANKS ALOT!!
lets try the pics again...
Any definate answers as to where they go, pics would be supurb, THANKS ALOT!!
lets try the pics again...
#14
Junior Member
Join Date: Dec 2001
Location: NC
Posts: 83
Likes: 0
Received 1 Like
on
1 Post
Car: 1989 Trans Am
Engine: 350 TPI
Transmission: 700R-4
that line should run into one of the wiring harnesses at the firewall. it's the vacumn line that applys vacumn to open the heater control valve when you switch on the heater control inside the car. if it is just hanging at the end it has broken off some where. just use a small piece of rubber tubing to connect them back together
#15
Member
Thread Starter
Join Date: Apr 2002
Location: Edison, NJ
Posts: 276
Likes: 0
Received 0 Likes
on
0 Posts
Cant seem to find it, any one know for sure on the locations for either? I guess that would explain why my heater blows around everywhere and not one location? Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Hotrodboba400
Firebirds for Sale
3
12-10-2019 07:07 PM