Maf
#1
Junior Member
Thread Starter
Join Date: Sep 2003
Location: Kansas City MO.
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Maf
I have a 62 Nova with a 350 TPI unit I put together. Everything is 87 5.7.. I am getting a weird code for the MAF sensor. Its a code 33. When I have my scanner hooked up "tech I" I can read the "Mass Air Flow" rate in g/s the next line is "Airflow" its also in g/s. When the code sets the "Mass Air Flow" will continue to read the value of the sensor but the "Airflow" will be stuck on a number usually around 47 g/s. I have replaced the MAF sensor 3 times and all 3 have acted the same. I am now leaning to a ground or short.. The code will not always set at the same time. Usally it would set at hwy speeds above 2000 rpm.. now it will set under 2000 rpm. I have checked all my grounds on the wire harness Ihooked them to one of the fuel rail bolts under the plemtimn, I have a ground from the left head to the master cyl, and one from the right front of the block to a cross member..
Any ideas???
Mitch
Any ideas???
Mitch
Thread
Thread Starter
Forum
Replies
Last Post
BumpaD82
Tech / General Engine
37
02-26-2016 02:57 PM