sd baseplate question
#1
Member
Thread Starter
Join Date: Aug 2003
Location: West Allis, WI
Posts: 186
Likes: 0
Received 0 Likes
on
0 Posts
Car: 85 iroc & 81 sc
Engine: 357 tpi 350 4bbl
Transmission: 700r4/ richmond 4speed
Axle/Gears: 9 bolt 3.45/3.42 8.5"
sd baseplate question
On the baseplate there is a hole with 2 bolt holes to hold a plate on. Thru research I found this is for an egr valve. I need to find a gasket for it. What year camaro or corvette used this egr valve here so I can pick up a gasket??? Thanks in advance.
#2
Supreme Member
iTrader: (2)
Join Date: Jul 2003
Location: Dallas, TX area
Posts: 3,205
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 Formula WS6 (Black, T-Tops)
Engine: 383 MiniRam (529 HP, 519 TQ - DD2K)
Transmission: Built '97 T56, Pro 5.0, CF-DF
Axle/Gears: 4.11 posi Ford 9"
91's used the EGR valve for sure. You can also just cut one out of some gasket material available at your local parts store.
Personally, I'd keep the EGR valve. Actually helps more than it hurts....
Personally, I'd keep the EGR valve. Actually helps more than it hurts....
#3
Member
Thread Starter
Join Date: Aug 2003
Location: West Allis, WI
Posts: 186
Likes: 0
Received 0 Likes
on
0 Posts
Car: 85 iroc & 81 sc
Engine: 357 tpi 350 4bbl
Transmission: 700r4/ richmond 4speed
Axle/Gears: 9 bolt 3.45/3.42 8.5"
Well everything for it has been deleted. The chip also deleted it. I got the engine compartment in pieces minus the short block. That will help though no one at the part store knew anything about it. THanks
Thread
Thread Starter
Forum
Replies
Last Post