Ignition coil not bolting up to intake?
#1
Member
Thread Starter
Join Date: Dec 2003
Location: Vineland, NJ
Posts: 236
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1987 IROC-Z
Engine: 350 TPI
Transmission: 700R4
Ignition coil not bolting up to intake?
SDPC intake base for vortec heads and TPI.
The holes for the ignition coil bracket aren't drilled it appears. Any suggestions?
The holes for the ignition coil bracket aren't drilled it appears. Any suggestions?
#3
Member
Join Date: Oct 2001
Location: Seattle
Posts: 401
Likes: 0
Received 0 Likes
on
0 Posts
Car: Which one?
Engine: 355
Transmission: 465
Can't make them work from what I found. Bolt hole spacing is too far apart, and that means the stock bracket is too narrow...you'd have to add metal to make it work IIRC.
You *might* be able to slot the one end, so one bolts in, the other slides under the other bolt, but I don't know as I like that idea as it relates to clamping the intake down. Then again, the Vortec intake requires so little bolt pressure to seal, it might work.
I mounted my coil on the firewall, but it's a different application so there were some spare threaded holes that worked.
You *might* be able to slot the one end, so one bolts in, the other slides under the other bolt, but I don't know as I like that idea as it relates to clamping the intake down. Then again, the Vortec intake requires so little bolt pressure to seal, it might work.
I mounted my coil on the firewall, but it's a different application so there were some spare threaded holes that worked.
Thread
Thread Starter
Forum
Replies
Last Post
Fast355
DFI and ECM
14
12-02-2016 06:33 PM
ambainb
Camaros for Sale
11
04-25-2016 09:21 PM
92camaroJoe
Tech / General Engine
6
08-13-2015 06:07 AM