TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

Needing some guidance with codes

Thread Tools
 
Search this Thread
 
Old 07-21-2012, 12:34 PM
  #1  
Junior Member
Thread Starter
iTrader: (1)
 
Royal_Z's Avatar
 
Join Date: Jul 2012
Posts: 10
Likes: 0
Received 0 Likes on 0 Posts
Needing some guidance with codes

I'm not sure if I am posting this in the correct place, if I'm not then I do apologize, but I have been doing a search and have not had any luck with the results. I am trying to figure out how I can read the codes off of my 91 Z with out using a scan tool. I've read in several threads that there is a way you can manipulate the system to flash the codes to you. Any and all help will be greatly appreciated. Thanks in advance
Old 07-21-2012, 01:08 PM
  #2  
Sponsor

iTrader: (92)
 
Tuned Performance's Avatar
 
Join Date: Dec 2004
Location: Mile High Country !!!
Posts: 15,458
Received 669 Likes on 592 Posts
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: Needing some guidance with codes

jumper with a paper clip the aldl pin a to b , turn the key to the accessory position and blink the codes. Fist code will be code 12 3 times then any other stored codes. To count the codes count the series of blinks code 12 is blink pause blink, blink. The aldl is under the dash driver side knee height.
http://www.chevythunder.com/fuel%20i...g%20pg%20A.htm
Old 07-21-2012, 01:17 PM
  #3  
Junior Member
Thread Starter
iTrader: (1)
 
Royal_Z's Avatar
 
Join Date: Jul 2012
Posts: 10
Likes: 0
Received 0 Likes on 0 Posts
Re: Needing some guidance with codes

Thank you thank you! Thanks a million
Old 07-21-2012, 01:25 PM
  #4  
Sponsor

iTrader: (92)
 
Tuned Performance's Avatar
 
Join Date: Dec 2004
Location: Mile High Country !!!
Posts: 15,458
Received 669 Likes on 592 Posts
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: Needing some guidance with codes

Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
IROCZ1989
North East Region
7
01-24-2016 03:55 PM
Ikes 91Z
LTX and LSX
21
12-09-2015 03:49 PM
kitt23
Exterior Parts Wanted
2
08-15-2015 12:37 PM
86camaroman201
Fabrication
0
08-11-2015 10:39 PM
GEmrsn
Interior Parts Wanted
3
08-08-2015 03:15 PM



Quick Reply: Needing some guidance with codes



All times are GMT -5. The time now is 09:34 PM.