Ten Years from now. Another motor build thread
#1
Junior Member
Thread Starter
Join Date: Nov 2002
Location: Crawlorado Springs Co
Posts: 66
Likes: 0
Received 1 Like
on
1 Post
Car: 91 z Clone
Engine: 6.4l LSX
Transmission: T56
Axle/Gears: s12 3.73
Ten Years from now. Another motor build thread
ten years from now i wanna be rockin my thirdgen
the trusty 350 TPI has worked well in this car since 87 and its time to give it some love
A little love
I'm not here to make 500 hp or spin the thing to the moon
i like the low end grunt i love the fuel mileage
its time to freshen up the motor though
Plan:
Mild port/match the intake plenum runners and base
gasket match the stock 083 heads to the intake
from the top down stock HG's .030 quench height?
not sure correct me if im wrong but stock the pistons sat .025 in the hole?
sealed power hypereutectic flat top pistons with 4 valve reliefs +6cc dish?
stock rods with good bolts
stock crank
this puts me around 10:1 CR i think?
for a cam im thinking
LPE 74211 211/219 .530/.560 112lsa OR
LPE 74219 219/219 .560/.560 112 LSA
1.6 Roller rockers
which cam do you all think would suit my application best?
will also run a 2400-ish stall
what valve springs does every one recommend?
what supporting mods am i missing?
i have hooker shorty's 2.5 crossover into a 3 inch to the back
AFPR already
thinking 21# injectors more? less?
the trusty 350 TPI has worked well in this car since 87 and its time to give it some love
A little love
I'm not here to make 500 hp or spin the thing to the moon
i like the low end grunt i love the fuel mileage
its time to freshen up the motor though
Plan:
Mild port/match the intake plenum runners and base
gasket match the stock 083 heads to the intake
from the top down stock HG's .030 quench height?
not sure correct me if im wrong but stock the pistons sat .025 in the hole?
sealed power hypereutectic flat top pistons with 4 valve reliefs +6cc dish?
stock rods with good bolts
stock crank
this puts me around 10:1 CR i think?
for a cam im thinking
LPE 74211 211/219 .530/.560 112lsa OR
LPE 74219 219/219 .560/.560 112 LSA
1.6 Roller rockers
which cam do you all think would suit my application best?
will also run a 2400-ish stall
what valve springs does every one recommend?
what supporting mods am i missing?
i have hooker shorty's 2.5 crossover into a 3 inch to the back
AFPR already
thinking 21# injectors more? less?
Thread
Thread Starter
Forum
Replies
Last Post
Linson
Auto Detailing and Appearance
40
08-21-2015 02:12 PM