help quick question thats driving me nuts look at pic and tell me what you think
#1
Junior Member
Thread Starter
Join Date: Apr 2010
Location: Sault ste. Marie, ON
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 iroc z
Engine: 5.0 TPI
Transmission: t5
Axle/Gears: stock
help quick question thats driving me nuts look at pic and tell me what you think
ok so i was in the middle of installing a new center bolt to perimeter bolt adapter to fit some tall valve covers, when i accidentally dropped a cylindrical washer that was part of the adapter down the hole that is in the head. im not exactly sure where it goes and whether i now have to pull the whole valve train to get it back out please any help
will attach photos
will attach photos
Last edited by snipzors; 08-01-2014 at 04:41 PM.
#2
Supreme Member
iTrader: (14)
Re: help quick question thats driving me nuts look at pic and tell me what you think
Maybe you'll get lucky and you can snag it with a long magnet. It's in your block's valley. If you can't get it with a magnet you'll need to pull the intake manifold and it should be right there. If it's at a far end of the block it could make it's way to your oil pan.
#4
Junior Member
Thread Starter
Join Date: Apr 2010
Location: Sault ste. Marie, ON
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 iroc z
Engine: 5.0 TPI
Transmission: t5
Axle/Gears: stock
Re: help quick question thats driving me nuts look at pic and tell me what you think
good call Sir!!!
Thread
Thread Starter
Forum
Replies
Last Post