TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

Car Sometimes Bogging During Braking Or When First Put Into OverDrive

Thread Tools
 
Search this Thread
 
Old 12-13-2021, 03:14 PM
  #1  
Senior Member

Thread Starter
 
Vinscully50's Avatar
 
Join Date: May 2013
Posts: 559
Received 15 Likes on 13 Posts
Car: 1986 Camaro IROC Z
Engine: LB9 305 TPI
Transmission: 700R4
Car Sometimes Bogging During Braking Or When First Put Into OverDrive

So I've started a ton of threads over the last few weeks since my car had 30 problems at once! (Bad alternator cable, bad MAF, bad MAF Relay, blown header gaskets, fouled plugs and bad spark plug wires).

After I fixed all of those problems my car has been running much better. The engine is quieter, I can rev it up to 5000 with ease and it feels faster. However, over the last few days my car occasionally bogs and wants to stall when braking (usually hard stops), sometimes during slow turns (think turning into driveway/15 MPH backroads) and sometimes after I start the car, after it warms up when I first shift in Reverse or Overdrive it acts like it wants to bog down then quickly recover.

Some drives it does it during all of these situations other drives not at all other drives only one or two. (Under braking/turning being the most common).

During braking it will bog down to below 500 RPM and then recover to 650-700. Same with when turning and first putting it into gear/reverse.

The gear/reverse it only seems to do that when my car is cold on it's first start, after it warms up it's fine.
Old 12-13-2021, 05:16 PM
  #2  
Supreme Member
 
Komet's Avatar
 
Join Date: Feb 2021
Location: WA
Posts: 1,050
Received 376 Likes on 277 Posts
Car: 1989 IROC-Z
Engine: L98 350 TPI
Transmission: 700R4
Axle/Gears: BW 9 Bolt / 2.77 Posi
Re: Car Sometimes Bogging During Braking Or When First Put Into OverDrive

Are you also braking in the slow turns? I'm thinking if the symptoms occur only when your foot is on the brake, maybe check the brake booster for vacuum related issues?
Old 12-13-2021, 10:54 PM
  #3  
Senior Member

Thread Starter
 
Vinscully50's Avatar
 
Join Date: May 2013
Posts: 559
Received 15 Likes on 13 Posts
Car: 1986 Camaro IROC Z
Engine: LB9 305 TPI
Transmission: 700R4
Re: Car Sometimes Bogging During Braking Or When First Put Into OverDrive

Originally Posted by Komet
Are you also braking in the slow turns? I'm thinking if the symptoms occur only when your foot is on the brake, maybe check the brake booster for vacuum related issues?
I was thinking that earlier. The symptoms only seem to occur when I step on the brake pedal. They don't occur in Park or Neutral at all.
I'll check that big vacuum line that runs from the booster to the manifold tomorrow.
Old 12-14-2021, 10:03 AM
  #4  
Senior Member

 
Denis.V's Avatar
 
Join Date: May 2002
Location: Santiago, CHILE
Posts: 507
Likes: 0
Received 5 Likes on 3 Posts
Car: 1986 Pontiac Firebird Trans Am
Engine: 305 Tuned Port Injection
Transmission: The famous 700R4
Axle/Gears: No idea
Re: Car Sometimes Bogging During Braking Or When First Put Into OverDrive

Vacuum.

Check COMPLETE lines system + gasket related + rubber air inlet for cracks
Old 12-16-2021, 02:10 PM
  #5  
Senior Member

Thread Starter
 
Vinscully50's Avatar
 
Join Date: May 2013
Posts: 559
Received 15 Likes on 13 Posts
Car: 1986 Camaro IROC Z
Engine: LB9 305 TPI
Transmission: 700R4
Re: Car Sometimes Bogging During Braking Or When First Put Into OverDrive

Ok, so I think I've narrowed down the problem. I'm 99% sure it's either the brake booster vacuum line that runs from the booster to the manifold or one of runs underneath the driver side fender.
I've replaced all of the other lines in the past and those are the only two. I'm sure that brake booster line is original as it says 12/06/85 on it.
Does anyone know the size of the brake booster line? I think I might have to order line as the autoparts stores are always sold out these days.


Does anyone know what size this is? 3/8? 1/2?

This runs under the driver side fender, the only other line I never replaced. it does look brittle. Anyone know where it runs too?
Old 01-02-2022, 05:32 PM
  #6  
Senior Member

Thread Starter
 
Vinscully50's Avatar
 
Join Date: May 2013
Posts: 559
Received 15 Likes on 13 Posts
Car: 1986 Camaro IROC Z
Engine: LB9 305 TPI
Transmission: 700R4
Re: Car Sometimes Bogging During Braking Or When First Put Into OverDrive

I replaced the vacuum line that runs from the brake booster to the intake manifold. (It's 11/32) and it made a small difference. Idle is more stable but sometimes at low speeds (usually when braking) my car still bogs and sometimes stalls.

Does anyone know where that vacuum line in the above picture runs too? I tried looking under the car and can't find it. Don't tell me I have to pop off the fender...
Old 01-03-2022, 04:18 AM
  #7  
COTM Editor

iTrader: (22)
 
QwkTrip's Avatar
 
Join Date: Mar 2001
Posts: 9,932
Likes: 0
Received 1,860 Likes on 1,274 Posts
Car: '89 Firebird
Engine: 7.0L
Transmission: T56
Re: Car Sometimes Bogging During Braking Or When First Put Into OverDrive

It goes to the vacuum ball. I think it's mounted under the driver's side battery tray?
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Black88Z
Tech / General Engine
21
12-23-2011 11:43 AM
Black88Z
Tech / General Engine
5
12-21-2011 12:04 PM
AWES0ME1
Transmissions and Drivetrain
3
12-20-2010 08:43 AM
Enyce31082
Tech / General Engine
3
07-20-2008 01:26 PM
kdxrider9262
TPI
4
05-28-2008 08:23 AM



Quick Reply: Car Sometimes Bogging During Braking Or When First Put Into OverDrive



All times are GMT -5. The time now is 03:07 AM.