T56 Clutch Fork Retaining Clip?
02-23-2006, 09:15 AM
#1
Junior Member
Thread Starter
Join Date: Feb 2004
Location: Brownsville, TX
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 B4C
Engine: 4-bolt 350 219cam Superram
Transmission: T56
T56 Clutch Fork Retaining Clip?
Does the thin metal retaining clip (which is held on with a rivet) serve an important purpose in the engagement or disengagement of the clutch? The fork I received with the T56 swap-kit I purchased has the clip bent up about half an inch where it meets the 'T' on the fork. Might this cause an issue? Thanks in advance.
02-23-2006, 10:37 AM
#3
Supreme Member
iTrader: (1)
Join Date: Sep 2005
Posts: 26,123
Received 1,688 Likes
on
1,283 Posts
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
I don't think it's necessary.... IIRC mine doesn't even have it.... but it would have made assembly alot easier. Which is probably why the factory put it there: one little clip is cheaper than having their assembly workers chasing clutch forks around on the floor.
11-21-2012, 10:20 PM
#5
Member
iTrader: (9)
Join Date: Aug 2006
Location: Los Angeles
Posts: 216
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 Iroc-Z
Engine: 355 AFR-195 FIRST Fuel Inj.
Transmission: T56
Axle/Gears: ??
Re: T56 Clutch Fork Retaining Clip?
Was the final verdict on this that the clip is not needed? My T56 does not have the clip.
Thread
Thread Starter
Forum
Replies
Last Post
Night rider327
Interior Parts for Sale
2
02-25-2016 09:50 AM
mygta87
Engine/Drivetrain/Suspension Wanted
0
09-14-2015 10:36 PM
