Problem wiring the cableX box
12-04-2006, 09:07 PM
#1
Member
Thread Starter
iTrader: (3)
Join Date: Feb 2006
Location: Danbury Ct
Posts: 115
Received 0 Likes
on
0 Posts
Car: 87 iroc
Engine: 5.7 ZZ4, AFR, Stealth Ram, Comp cam
Transmission: 1993 T56 viper internals w Spec3+
Axle/Gears: moser 9" truetrac 3:89
Problem wiring the cableX box
I just did the T56 swap. My problem is I don't see how to properly wire the cable X box. Do both wires (white and black) get connected to the 2 wires from the VSS sensor? I don't know which one is the signal wire or ground wire. One is purple the other is yellow.On the instructions it has the ground side of the sensor also wired into a chassis ground. And does the red one get powered to 12Volts? Why can't you just connect to the sensor instead of running another seperate wire to chassis ground? Anybody with the cableX box can you help me please?
Last edited by 1hotroc; 12-04-2006 at 09:15 PM.
12-05-2006, 10:25 AM
#2
Member
iTrader: (1)
Join Date: Feb 2005
Location: Rapid City, SD
Posts: 266
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Camaro RS/SS
Engine: LT1
Transmission: T-56
Axle/Gears: 10 bolt with 3.42
Red wire gets IGN 12V, black wire gets ground, and the white wire gets the signal wire from the VSS. One of the VSS wires is the signal and the other is a ground.
12-05-2006, 05:44 PM
#3
Member
Thread Starter
iTrader: (3)
Join Date: Feb 2006
Location: Danbury Ct
Posts: 115
Received 0 Likes
on
0 Posts
Car: 87 iroc
Engine: 5.7 ZZ4, AFR, Stealth Ram, Comp cam
Transmission: 1993 T56 viper internals w Spec3+
Axle/Gears: moser 9" truetrac 3:89
I guess I am over analyzing the wiring. I will wire it the way I think it should go and see what happens.
Thread
Thread Starter
Forum
Replies
Last Post
db057
TBI
10
08-11-2015 10:11 PM
