Where to put transmission temp sender?
08-11-2007, 12:36 PM
#1
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Oct 2004
Location: Worcester, MA
Posts: 3,361
Likes: 0
Received 1 Like
on
1 Post
Car: 86 T/A
Engine: HSR 355
Transmission: 700R4
Axle/Gears: 2.77 posi
Where to put transmission temp sender?
I was going to tap into a line running to a cooler but I think it'd be better to measure the temp in the transmission pan. It could probably double as a hole to drain the fluid if its at the bottom of the side of the pan. Any comments from someone familiar with transmissions? Good idea/ bad idea?
08-11-2007, 01:30 PM
#2
Moderator
Join Date: Aug 2004
Location: Nanticoke, Pa
Posts: 1,367
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Firebird
Engine: 406 CI
Transmission: Pete K 700R4
Axle/Gears: 3:55
Re: Where to put transmission temp sender?
Bang a hole in the ban, if you have room, and use a drain plug kit. The center is a 1/8 npt thread, and the sender will usually screw right in. I have done quite a few with no trouble.
08-11-2007, 11:46 PM
#3
Moderator
Join Date: Jan 2000
Location: Mercedes Norte, Heredia, Costa Rica
Posts: 20,981
Likes: 0
Received 9 Likes
on
8 Posts
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
Re: Where to put transmission temp sender?
I drilled a hole in the pan and tacked a weld nut on the inside.
08-12-2007, 12:55 AM
#4
Supreme Member
iTrader: (1)
Join Date: Feb 2000
Location: Norfolk, VA. USA
Posts: 7,964
Likes: 0
Received 3 Likes
on
3 Posts
Car: 86 Trans Am, 88 Formula
Engine: 95LT4, 305TPI
Transmission: T56, T5
Re: Where to put transmission temp sender?
We used a drain plug kit for the sender we put into the 82.
just make sure that there is clearance for the sender so it doesn't hit the valvebody.
just make sure that there is clearance for the sender so it doesn't hit the valvebody.
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
04-25-2016 09:21 PM
NBrehm
Engine/Drivetrain/Suspension Parts for Sale
1
08-25-2015 11:49 PM
4l60, drain, kit, pan, plug, put, sender, side, temp, temperature, trannsmission, trans, transmission
