T5 slips out of reverse
06-25-2008, 09:59 AM
#1
Member
Thread Starter
Join Date: Nov 2006
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
T5 slips out of reverse
i may have an opportunty at a complete t5 set up. the tranny sometimes slips out of reverse. how do you fix this, and is it a big deal? he told me to just apply some pressure to the shifter which, to me, seems like an easy fix.
06-25-2008, 02:41 PM
#3
Junior Member
Join Date: Jun 2007
Location: MN
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 IROC-Z
Engine: 305 H.O.
Transmission: 5 Speed
Axle/Gears: 7.5" 10 bolt, 4.10, torsen posi
Re: T5 slips out of reverse
Could be the 1/2 slider (the reverse gear is on the outside of it)
Could be the reverse idler
Could be the shifter bushing/selector parts in the tail not allowing it to go all the way in.
If it is ok in all the other gears and is quiet it should be a cheeper fix
I can help you with parts if you need any
Could be the reverse idler
Could be the shifter bushing/selector parts in the tail not allowing it to go all the way in.
If it is ok in all the other gears and is quiet it should be a cheeper fix
I can help you with parts if you need any
06-25-2008, 04:10 PM
#5
Junior Member
Join Date: Jun 2007
Location: MN
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 IROC-Z
Engine: 305 H.O.
Transmission: 5 Speed
Axle/Gears: 7.5" 10 bolt, 4.10, torsen posi
Re: T5 slips out of reverse
It should be ok for a while that way, it will speed up the wear on the reverse fork but unless you plan on spending a lot of time in reverse it will take a while to hurt it.
Thread
Thread Starter
Forum
Replies
Last Post
UltRoadWarrior9
Transmissions and Drivetrain
3
09-02-2015 08:24 PM
