Help! How can I get this drive gear off
05-23-2010, 07:34 PM
#1
Junior Member
Thread Starter
Join Date: May 2003
Location: Riverdale, GA
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 Trans Am
Engine: 350 Roch-4bbl
Transmission: 700R4
Axle/Gears: Normal
Help! How can I get this drive gear off
How can I get this drive gear off.
its a 700r4 from a 91-93 chevy truck
I see there is a little hole for a drive gear clip. Is that correct?
Thanks
its a 700r4 from a 91-93 chevy truck
I see there is a little hole for a drive gear clip. Is that correct?
Thanks
Last edited by juansupreme; 05-23-2010 at 07:38 PM.
05-24-2010, 04:28 PM
#2
Senior Member
iTrader: (1)
Join Date: Mar 2005
Location: San Antonio
Posts: 646
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1981 Camaro; 1986 Z28
Engine: LT1; LT1
Transmission: 6 speed; 6 speed
Axle/Gears: 3.73; 3.42
Re: Help! How can I get this drive gear off
You can either use a long two jar puller or do what I did. I used a cutoff wheel and cut the reluctor wheel until it just bareley got to the output shaft then I pried it apart. I knew I wasn't going to use mine so it didn't matter if I broke the ring.
Thread
Thread Starter
Forum
Replies
Last Post