firechicken76

iTrader: (3)

Ive got a moser 9" installed in my 84 t/a and there is a bolt on top that connects the panhard(?) bar to the trans, well when i go over a bump the bolt hits the body of the car, ive got eibach 1" lowering springs, would switching to a gta spring in the back help out this problem? i only have gta springs handy, no stock 84 springs, are gta springs lower than standard 84 t/a springs? stiffer? what other options do i have other than cutting a hole in my body where the bolt hits...and i dont really want to do that.

84 z28

How are your shocks ? The rear end should be hitting the bump stops before anything else.

Scorpner

iTrader: (4)

Broken tranny mount?

//<86TA>\\

iTrader: (14)

thats normal with the moser 9 and lowered cars, it will "clearance" itself. I have a hole in the floor above and to the left of the tunnel from the bolt.

however, check to see if the rear is centered, it may be off to the driveside more and making it worse.

firechicken76

iTrader: (3)

I have an adjustable torque arm? the bar that goes from left to right in the back, how do you adjust it? it might not be centered all the way, would it be easiest to do jacked up off the ground?

Tobias05

You'll need an adjustable aftermarket panhard bar. The factory piece is a flimsy stamped rubber abomination...I still own two.

120ish from spohn or umi.

Yup, measure the distance from the wheels to the fender and then jack her up.

firechicken76

iTrader: (3)

ive got an adjustable bar, cant remember what brand, maybe edlebrock.

http://www.autopartswarehouse.com/de...e&apwidxPtRqZd

thats the one!

Tobias05

sweet, at least you can adjust that one on the car. worth the extra couple bucks!

firechicken76

iTrader: (3)

It was on the car when i bought it, so were aftermarket shocks, tubular lower control arms, springs, torque arm, and stut tower brace....ill be selling the stb soon though.

Tobias05

Are you getting a different one?

I know 4th gens don't benefit from them, but 3rd do...

firechicken76

iTrader: (3)

installing a magnacharger on the ls1, so i wont have room for it.

tom86iroc

iTrader: (1)

i just banged the body up with a hammer just enough to clear the bolts no biggie and you'll never know or see where you banged it up

firechicken76

iTrader: (3)

That sounds the easiest, lol, ill do that.

tom86iroc

iTrader: (1)

lol was for me just use a large drift to small you'll poke a hole and a big hammer 10 shots that's all it takes