T56 driveshaft pics?
#1
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Feb 2003
Location: check under the car
Posts: 1,143
Likes: 0
Received 4 Likes
on
3 Posts
Car: White 25th Anniversary RS
Engine: lt1
Transmission: t56
Axle/Gears: 4:10
T56 driveshaft pics?
I was wondering if anyone has a pic of how far their driveshaft goes into their t56? I was looking at mine and I think it might be too short. I had it shortened when I installed the ls t56. Now I am thinking I might have measured wrong. It works fine but there's like an inch of shaft showing between the dust seal And the yoke.
#3
Supreme Member
iTrader: (4)
Re: T56 driveshaft pics?
Take measurements.
Determine how far into the tailhousing bushing the yoke is inserted. That bushing is an inch or 1.5" wide. If it's into 100% of the width of the bushing, you're fine because the spline depth is more than adequate at that point.
Determine how far into the tailhousing bushing the yoke is inserted. That bushing is an inch or 1.5" wide. If it's into 100% of the width of the bushing, you're fine because the spline depth is more than adequate at that point.
#4
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Feb 2003
Location: check under the car
Posts: 1,143
Likes: 0
Received 4 Likes
on
3 Posts
Car: White 25th Anniversary RS
Engine: lt1
Transmission: t56
Axle/Gears: 4:10
Re: T56 driveshaft pics?
I will snap a pic tomorrow. Back when I did the ls tranny on a lt1 I was one of the first, so there was no information out there. It just looks like it's not in far enough for some reason.
#5
Senior Member
Join Date: Oct 2007
Location: Winnipeg, Manitoba
Posts: 590
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 Camaro IROC-Z
Engine: 565ci 900 hp
Transmission: T56 Magnum by RPM Transmissions
Axle/Gears: Moser 9" w/4:56 Detroit Locker
Re: T56 driveshaft pics?
I Have an LS tranny and yoke is always in the boot seal, you can see any of the splines of the out put shaft. This is best picture I have.
#6
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Feb 2003
Location: check under the car
Posts: 1,143
Likes: 0
Received 4 Likes
on
3 Posts
Car: White 25th Anniversary RS
Engine: lt1
Transmission: t56
Axle/Gears: 4:10
Re: T56 driveshaft pics?
Is this ok? Keep in mind seal is not what's showing, that's just a dust seal. The actual seal is flush with housing. So it looks like I have about a couple inches of shaft inside tranny.
Trending Topics
#8
Supreme Member
Join Date: Dec 2000
Location: stallings,n.c.
Posts: 1,271
Likes: 0
Received 1 Like
on
1 Post
Car: 1989 camaro rs convertable
Engine: 305 tbi
Transmission: 700r4
Axle/Gears: 7.5"3.42 gears forth gen 2000 camar
Re: T56 driveshaft pics?
you should knock the rust off or it will kill that seal.
Thread
Thread Starter
Forum
Replies
Last Post
IROCZDAVE (88-L98)
Engine/Drivetrain/Suspension Parts for Sale
1
11-19-2015 07:03 AM