Will these headers/turbo work...
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jan 2004
Location: Southern California
Posts: 81
Likes: 0
Received 0 Likes
on
0 Posts
Will these headers/turbo work...
This is a kit for a fiero 2.8-3.1-3.4, decent price, and is available currently until Doward's hits the market... also has headers... Think they will work with the v-6 F-body?
http://www.turbochargerpower.com/turbo.htm
http://www.turbochargerpower.com/turbo.htm
#2
Supreme Member
Join Date: Dec 2000
Location: Tucson, AZ, USA
Posts: 2,375
Likes: 0
Received 0 Likes
on
0 Posts
Car: '99 Trans Am, '86 Camaro
Engine: LS1, Scrap
Transmission: T56, T5
Axle/Gears: 3.42 Stock ZT, 3.42 Open
Without even looking, no. The fiero is a transverse mid-engine car. Neither the exhaust plumbing or the turbocharger location will take an F-body's engine compartment into consideration. Likely end up with the turbo trying to sit in a strut tower or in the firewall..
The turbo itself would work, probably even the oiling system, perhaps just about everything but the exhaust.. but that's alot to pay if you're not using the exhaust components.
The turbo itself would work, probably even the oiling system, perhaps just about everything but the exhaust.. but that's alot to pay if you're not using the exhaust components.
#3
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jan 2004
Location: Southern California
Posts: 81
Likes: 0
Received 0 Likes
on
0 Posts
Thanx for the input, thought it just might work with all the room in front of my engine. Maybe by the time i get my modded 3.4 in, the vortex turbo kit will be ready.
#5
Senior Member
Join Date: Oct 2002
Location: Herrin IL
Posts: 694
Likes: 0
Received 0 Likes
on
0 Posts
Car: 98 Trans Am 85 Trans Am
Engine: LS1 Lg4
Transmission: 4L60E 700r4
Axle/Gears: 3.23 2.73
The setup for the fiero would more than likely put the turbo inside of you dash. Those polished stainless headers look just like the manifold that came from the factory on my fiero I had a few years back except in stainless.
#6
Supreme Member
Join Date: Dec 2000
Location: Tucson, AZ, USA
Posts: 2,375
Likes: 0
Received 0 Likes
on
0 Posts
Car: '99 Trans Am, '86 Camaro
Engine: LS1, Scrap
Transmission: T56, T5
Axle/Gears: 3.42 Stock ZT, 3.42 Open
Uhm... wow.. those are log manifolds, not headers. Ghetto.
Thread
Thread Starter
Forum
Replies
Last Post
Xenodrgn
Tech / General Engine
17
12-11-2001 07:56 PM