Timming problem ? Error code 33
05-02-2007, 12:40 PM
#1
Junior Member
Thread Starter
Join Date: Apr 2007
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Timming problem ? Error code 33
I have a 1992 RS 3.1. The car acts as thought is has a timming problem. I checked the error code, code 33 came up . I replaced the MAP sensor but to no avail. The car starts fine bet when you accelerate it hesitates and misses. I changed the fuel filter, checked for vacume leak, had the fuel injectors cleaned and Emptyed the gass tank to make sure there was not some baf fuel. Amy suggestons
Last edited by JCP1992; 05-02-2007 at 12:46 PM.
05-02-2007, 04:10 PM
#2
Senior Member
iTrader: (5)
Join Date: Nov 2006
Location: Tallahassee, FL
Posts: 1,517
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 V6 Camaro
Engine: 2.8
Transmission: 700R4
Axle/Gears: 3.42 open diff
Re: Timming problem ? Error code 33
Change your plugs, wires. and at least check the distributer cap for corossion.
05-03-2007, 07:57 AM
#3
Member
Join Date: Jan 2007
Location: Pottstown PA
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 Trans Bird
Engine: 3.1 MFI
Transmission: 700r4
Axle/Gears: Stock
Re: Timming problem ? Error code 33
Just to let ya know. The knock sensor retards timing and creates a really bad hesitaion. Its located right above the starter mine had a broken pig tail and was off. When i started up and ran cold it ran fine then after a while it got a huge hesitation and stalled out at lights and idled ruffly around 600-500 rpms.
If broken the pig tail was $15
And the knock sensor is $35 non returnable
If broken the pig tail was $15
And the knock sensor is $35 non returnable
Last edited by XxSgtReillyxX89; 05-03-2007 at 08:05 AM. Reason: Gave more detail
05-03-2007, 08:28 AM
#4
Junior Member
Thread Starter
Join Date: Apr 2007
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Re: Timming problem ? Error code 33
I had all ready change out the knock sensor and replaced the connector. It was causing my check engine light to come on. Thanks for responding
----------
I have changed out the plugs and wires so I guess the next step is the distributer cap. Thanks
----------
I have changed out the plugs and wires so I guess the next step is the distributer cap. Thanks
Last edited by JCP1992; 05-03-2007 at 08:31 AM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post