i have no clue whats wrong
#1
i have no clue whats wrong
This doesnt happen all that often but sometimes when I go to start my 92 camaro rs 3.1L it just kinda clicks and thats about all. but if i wait a minute or two it will start like nothing is ever wrong. one more thing sometimes when i stop i will hear a clanging noise coming from under the hood somewhere it almost sounds like a chain or something but i dont know anything about cars except i own one so any help will be greatly thanked
#2
Junior Member
Join Date: Sep 1999
Location: Winnipeg Manitoba. Canada
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
Is the noise a clicking or a grinding?
If it is clicking its sounds like your starter . If it is grinding it could also be your flywheel .
Check all your starter wires to see if you have a loose connection. Could just be a losse wire.
------------------
If it is clicking its sounds like your starter . If it is grinding it could also be your flywheel .
Check all your starter wires to see if you have a loose connection. Could just be a losse wire.
------------------
#3
Supreme Member
Join Date: Mar 2000
Location: St. Louis, MO
Posts: 2,028
Likes: 0
Received 0 Likes
on
0 Posts
Car: 85' Firebird (Project), 92' RS
Engine: 2.8L, LS1
Transmission: 700R4, 4L60E
Axle/Gears: 3.42 Open , 10 Bolt (ukn)
knighthelm, said it right. check all your starter wires, the starter motor might actually be going bad. If you have a good mechanic, (an honest one) you might have him check it out. Now, when was the last time you did a full tune up? This could make a difference in the way it runs, and possibly in how easy it is to start up.
#4
Supreme Member
Join Date: Jun 2000
Location: Moorpark
Posts: 2,937
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 CAMARO 1968 FIREBIRD
Engine: CAMARO 3.1L FIREBIRD 455
Transmission: CAMARO 700R4 FIREBIRD TH-400
i had the same problem replaced the starter to no avail it was the computer flooding out my egnie i would have to wait liek 2 mins of cranking to start it once i replaced it no problems it also caused my tranny to be in lockup all the time and fryed it
Thread
Thread Starter
Forum
Replies
Last Post
RedLeader289
Tech / General Engine
10
05-28-2019 01:47 PM