Anyone do this yet?
Thread Starter
Senior Member
Joined: Oct 1999
Posts: 786
Likes: 1
From: Austin, Tx
Car: 92 Formula
Engine: L98
Transmission: A4
Anyone do this yet?
I remember a while back, some people were planning on fabricating a 4th gen TA nose onto a thirdgen bird.... The photoshop pics looked pretty sweet, I am just wondering if anyone has done it yet...
Joined: Jan 2001
Posts: 8,030
Likes: 1
Car: 1989 IROC-Z
Engine: 383 stroker
Transmission: 700R4 3500 stall, TransGo shift kit
Axle/Gears: Moser 9", 4.11:1
Yeah it did look sweet, but I don't believe anyone has attempted it yet. I think it would look dumb from the side. Too round go good with the squared off rear end.
Supreme Member
Joined: May 2002
Posts: 1,287
Likes: 1
From: Northern Ohio
I don't have a trans am, or firebird, but the whole front end is fiberglass right? You could probably could probably fit the 4th gen over top of the 3rd gen, then cut the third gen somewhere where they match up halfway decent, then fiberglass the two pieces together and bolt it on. Bondo makes a fiberglass repair kit that would probably work for this application.
Mathius
Mathius
TGO Supporter
Joined: Nov 2001
Posts: 11,634
Likes: 3
From: Maryland; USA
