Pics of the Z, center exit exhaust etc
Trending Topics
Thread Starter
Senior Member




Joined: Jun 2001
Posts: 922
Likes: 33
From: Kansas
Car: 91 Z28
Engine: 6.0L LQ9
Transmission: T56
Axle/Gears: Dana 44 3.92
Sorry about the crappy pics, my digital camera sucks. I've got a buddy scannin a role of film for me, so hopefully i can put those up soon.
As far as pics from underneath, nope, none. The pipes are lookin a little not so good right now, need to take them off and paint them again. I can tell you it takes a full stick on each side of the crossflow to get them like that. Also you need really short tips, otherwise they are gonna have to be angled up goofy.
Marc
As far as pics from underneath, nope, none. The pipes are lookin a little not so good right now, need to take them off and paint them again. I can tell you it takes a full stick on each side of the crossflow to get them like that. Also you need really short tips, otherwise they are gonna have to be angled up goofy.
Marc
Supreme Member

Joined: Jun 2002
Posts: 4,029
Likes: 6
From: Illinois
Car: 1988 Trans Am
Engine: 305 TPI
I am a big fan of center exhaust, but it looks kind of out of place when it is not integrated with the bumper. I like it best on mid engined cars for some reason.
Yours looks OK (supertrapps yuck) . If yours went through a notch in the ground effects, so they would be level with the GFX would be "killer" (saying killer is like putting supertrapps on anything but a midget racer or a ATV, yuck!!!! my 2 cents)
Everyone has their own taste...you asked.
Everyone has their own taste...you asked.
Thread Starter
Senior Member




Joined: Jun 2001
Posts: 922
Likes: 33
From: Kansas
Car: 91 Z28
Engine: 6.0L LQ9
Transmission: T56
Axle/Gears: Dana 44 3.92
The pics don't do the exhaust justice. You either love it or you hate it, there is no gray area. Its different and thats why I did it. I have yet to see one like it, and thats what I was going for. Sounds good without the bigger diameter tips to mellow out the tone.
And yes it probably would look better cut into the gfx's, but good luck fittin the tips in there. Not much room between the 'hole' and the gfx's.
Marc
And yes it probably would look better cut into the gfx's, but good luck fittin the tips in there. Not much room between the 'hole' and the gfx's.
Marc
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
colton_carlson
Firebirds for Sale
7
Mar 8, 2019 12:21 PM






