I was looking to put some stripes on my front left quarter panel, The racing stripes.
I have a sheet of black decal paper and was going to cut my own.

Can someone give me some measurements? Like width, length, ect?
Do they go right in the middle of the fender, like centered on the wheel well basically?
I know there on an angle, If you know the angle that would be great to.
But i can get that close by lineing it up.

Thanks

 

do you mean front fender stripes? or rear quarter panel stripes

 

Front quarter,drivers side

 

can you take a pic and photoshop what you are lokking to achieve?

or are you talking about the stock style stripes? if so they run right on top of the lip where the ground fx meet the fender.

 

The white stripes on the fender.
Need to know thew width, length, etc?

 

hmmm never seem those...sorry

 

Those are Gran Sport (Vette) stripes....

 

Cant go wrong with these chrome ones...They might look good in silver or white too.

 

My son's black 96 Vette has them. I can go out, pull the car cover and measure them if you think that would help you.

Let me know.

Jake

 

I changed my avatar to show a shot of my son's Vette with the stripes. I have other shots that may help you. If you'd like me to send them, email me jcameron266@sbcglobal.net

As I said in the PM, I measured them and they are 2-3/4" wide and spaced 13/16" apart.

Hope this helps.

Jake