Just thought I'd show yall the end result of my year long resurrection project. As yall may know the car in my sig was totaled and i went out and bought this red 91 z28 and went nuckin futs with it. Enjoy!

nice job. I like the matte finish and the wheels. whats the motor details?

Thanks, actually I used a black aluminum wrap with this car instead of satin black on the other car. Engine details below:

Built DART SHP 406ci with T76 turbo all forged internals
Eagle forged crank
Scat H-beam 6" rods
AFR 195 Eliminator heads
280xfi cam
1.6 roller rockers
Cloyes double roller timing chain
LS style lifter retainer(allows you to change cam without removing the intake)
Accel Superrram modded
Edelbrock TPI highflow intake ported
BBK 58mm TB
Turbo setup is pieced together and custom piping
3.5" SS downpipe
All stainless steel headers(driver side SLP header and passenger side is a modded BBS style turbo header)
Exhaust is put together with vband clamps. I can disassemble the entire exhaust in less than 10 min.
Also entire fuel system is custom made with braided lines and TPI rail has been fitted with -8an fittings
Dual Walbro intank pump setup with the second pump coming on at 5psi via Hobbs switch

I like this version even more than the last. Awesome work!

Nice work. How come you put RS badges on a Z28 though? or was that a typo?

Those are the ground effects from my other car the 92 RS. They were in better shape

"and went nuckin futs with it"

You sure did! Looks awesome!

Thanks yall, I have an SS hood that will eventually make its way on the car. I'm leaving it off for now while tuning so I can see the engine catch fire sooner to put it out lol

Looks freaking awesome dude, good job. I want those wheels lol

Looks good. Great job!

Awesome Build!!! Love the look of the paint against wheels!!

Awesome job!! What kind of wheels are those? What size?

They are XXR 531 18x9 front and 18x11 rear. They are 114mm bolt pattern but they've been redrilled to 5x120mm to fit out patterns. Actually the fronts were redrilled. I'll have the rears redrilled later

Hey man what's the offset on these?

I think they are 38mm offset. The fronts have a 3/4" spacer and rear 1/2"

i normally hate flat black third gens but good lord this car is stunning,i want it bad

Awesome!

May want to take the fresh air line from t-body to pass valvecover and route it to the turbo inlet so it doesn't put psi in the crankcase. Then block off the t-body port.

hey what was the exact name of the hood you eventually got because i can only find similar ones but they do not have the little vents on the sides? was it custom made?

It's a Duraflex SS hood. The side vents I got from ebay I added afterwards . Haven't been on here for quite a while but I still have the car collecting dust in the garage. Took up the off-roading hobby now.