I want to know what you guys have done for cup holders. If you custom made some or have some aftermarket or incorporated stock, lets see it. I need ideas

 

Dude.........buy you the 91-92 Firebird door panel cup holders for your ride, u will need to drill the mounting holes for it if u have power windows, if u have manuel windows i dont think they will clear the window crank............its something for you to consider if u want cupholders for both doors.......my .02............

1992 Pontiac Tran am, WS6, 305 V-8 accell wires,cap,rotor,coil,weiland water pump,auto trans with under 58,000 miles on it.

 

Mine has an after market one screwed to the side of the console. It folds out, looks OK, I'm not sure that I would have put it in myself, but it was in the car when I bought it.

 

I bought a set of the stock cup holders that were in the 91-92 Firebirds. I love them, the fit perfectly, and are in a great position. Only one drawback to them; you must have power windows, or the window crank will get in the way.

 

Here is mine. I made it from two 2x6's glued together. It works great. The best part is, if I have a can of something in there, I can shut the console lid and my beverage stays cold.

Also, does anyone have a picture of the firebird cup holders? And where would I get them from?

 

Lets not forget the Tech article on cupholders from the main page(I know the fact that this site isn't just forums is a surprise to some). https://www.thirdgen.org/newdesign/tech/cupholder.shtml

This is what I am going to be doing to mine next week.

 

mine does.

 

heres mine......i like it and it holds drinks good

 

I used the 97+ F-body Center console to get my cupholders,

 

I have a set of the door cupholders passanger and driverside if anyone makes me a good offer on them ill sell them im just too lazy to put them in.