ERS Dash Emblem...
Thread Starter
Supreme Member
iTrader: (4)
Joined: Feb 2000
Posts: 2,850
Likes: 0
From: Winston salem, NC
Car: 1987 1SICIROC.....1999 TransAm
Engine: 385 HSR.....LS1
Transmission: 700R4 with Midwest 3400 2.4str...M6
Axle/Gears: SLP Zexel Posi unit 3.42's...3.73's
ERS Dash Emblem...
I want to take mine off cause I removed all the stock system scrap but whats under it? Is it held on just by glue or are there pegs on it so when I remove it I will be left with hold in the dash where it was.
Let me know?
Ignore that ugly *** shifter handle...B&M Mega shifter on the way.
Let me know?
Ignore that ugly *** shifter handle...B&M Mega shifter on the way.
Last edited by Wishmaster's87IROC; Jan 18, 2003 at 09:44 PM.
Thread Starter
Supreme Member
iTrader: (4)
Joined: Feb 2000
Posts: 2,850
Likes: 0
From: Winston salem, NC
Car: 1987 1SICIROC.....1999 TransAm
Engine: 385 HSR.....LS1
Transmission: 700R4 with Midwest 3400 2.4str...M6
Axle/Gears: SLP Zexel Posi unit 3.42's...3.73's
well darn, NOW WHAT? I guess if I really want it out I could patch the holes somehow...
Supreme Member
Joined: Jul 2001
Posts: 2,760
Likes: 0
From: Cove, Arkansas
Car: 85 Camaro SC
Engine: V6
Transmission: 700r4
Wishmaster's87IROC, you could shave off the letering and put some kind of emblem or your name on it? Hg, last time I looked at my classicindustries catalog they had them. You could check on their website. www.classicindustries.com
Supreme Member
iTrader: (2)
Joined: Jul 2001
Posts: 1,823
Likes: 1
From: San Antonio, TX
Car: 1988 IROC-Z
Engine: L98 (350 TPI)
Transmission: MD8 (700 R4) + 3.42 LS1 Rear
it's held on by 2 10 mm "self threading"? nuts. it will leave two little holes. IMO leave it there. 
Thread
Thread Starter
Forum
Replies
Last Post
