Gauge pod ????'s
Thread Starter
Supreme Member
Joined: Dec 2001
Posts: 1,282
Likes: 1
From: Elkton MD USA
Car: 1983, 1986
Engine: 2.8 2bbl, 2.8 MPFI
Transmission: 200C 3 speed, 700R4
Axle/Gears: 3.08, 3.42
Gauge pod ????'s
Well after months of searching I have not found a 2 5/8 inch A-pillar gauge pod for my 83 Camaro. Has anyone installed one that was intended for a 4th gen? I noticed that they make a 2 5/8 inch A-pillar pod for 4th gens but not for 3rd gens (figures)
Supreme Member
Joined: Sep 2001
Posts: 2,308
Likes: 2
From: winthrop harbor, il & plymouth, il
Car: 1986 camaro
Engine: 383 sbc
Transmission: th-400
Axle/Gears: 4th Gen 10 bolt/Detroit TrueTrac 4.
i know they make them and for while there many people angry cuz they were on backorder for long periods of time. this may still be the case with some companies who carry them.
Member
Joined: Aug 2002
Posts: 419
Likes: 2
From: Bellevue, NE
not sure if these are on backorder but go here http://www.gaugepods.com/fbody.htm
Thread
Thread Starter
Forum
Replies
Last Post
