reply
Thread Starter
Junior Member
Joined: May 2003
Posts: 9
Likes: 0
reply
Options for your Camaro's. I have an 02' Z28 
with Crazy Lighting
I work for "editted".com.
3rd Gen you want 6 1/2" x 4 1/8 H4 Sealed Beam Conversion Lenses that carry an H4 bulb in the rear. This replaces the Stock H4656 in the 3rd Gen Camaros. Then you can put H4 Halogen Bulbs in the sockets such as PIAA's or HIDS from us. Same goes for the high beam..
4th Gen
LT1 - you need to upgrade the factory sealed beam once again, good luck they are hard to come by. (I have HID versions available)
LS1 - 9006 Bulbs in your lows , 9005 in your highs , I have HIDs for both and PIAA Also makes bulbs for both. and DEPROJECTORS made by Hella in your fog lamps, also available in HID. They are direct replacement for the OEM fog lamp which sucks. These are the same fog lamps OEM on the Porsche 996.
Anyone in New England , ill install your stuff if you attend the New England Fbody Meets... www.nefbody.com
with Crazy Lighting I work for "editted".com.
3rd Gen you want 6 1/2" x 4 1/8 H4 Sealed Beam Conversion Lenses that carry an H4 bulb in the rear. This replaces the Stock H4656 in the 3rd Gen Camaros. Then you can put H4 Halogen Bulbs in the sockets such as PIAA's or HIDS from us. Same goes for the high beam..
4th Gen
LT1 - you need to upgrade the factory sealed beam once again, good luck they are hard to come by. (I have HID versions available)
LS1 - 9006 Bulbs in your lows , 9005 in your highs , I have HIDs for both and PIAA Also makes bulbs for both. and DEPROJECTORS made by Hella in your fog lamps, also available in HID. They are direct replacement for the OEM fog lamp which sucks. These are the same fog lamps OEM on the Porsche 996.
Anyone in New England , ill install your stuff if you attend the New England Fbody Meets... www.nefbody.com
Last edited by RCR; May 29, 2003 at 11:47 AM.
Senior Member
Joined: Jul 1999
Posts: 851
Likes: 1
From: Shelby Twp., Mi., USA
Car: '84 Fiero ('01 GA interior)
Engine: '96 4.0 Aurora
Transmission: '96 4T80E
Jeff, I don't want to sound like a tyrant or anything, but this is a tech board. If you are offering technical info, that is great. If you are here to hock your products, I can suggest that you contact the site admin and becoming a sponsor. This is why I took your link out.
Last edited by RCR; May 29, 2003 at 11:49 AM.
Thread Starter
Junior Member
Joined: May 2003
Posts: 9
Likes: 0
Thread
Thread Starter
Forum
Replies
Last Post