I installed a 4th gen console, but I cannot get the part that goes over the radio back in. For the life of me I cannot get any of the holes to line up. Does anyone have and pictures of where everything goes, or atleast a picture of it partially disassembled. I think i'm getting ready to go out there with a big tube of glue and make it fit

 

lol well duct tape fixs everything! j/k

from what i hear it should just line right up

 

Are you talking about the black trim piece? look and see if the console is pushing up the radio pod so you can't fit it on. Other than that, I can't think anything that wouldnt let you get it on.

 

Hmm, I guess ill just keep at it. Maybie I have the metal piece around the heater controlls in upside down, but I really doubt that.
THe thing getting me is that it looks like the angle of the radio pod is completley wrong. like 1 screw almost lines up, be the other is about half an inch back from the trip piece.
My friend said he would finish it for me if I went and got food, so I figured good deal, well he never got everything back in, and i'm not quite sure what he did taking it apart. Stupid me

 

Can someone tell me the metal bracket around the heater controlls does it go above or below the controlls(the bar across visable from the front)?

 

dont blame yourself,its probably something really minor...keep at it & im sure you will figure it out make sure we see some pics when its all done